Antonio Massarini

Antonio Massarini

Auto-generated profile, based on publicly available information

Antonio Massarini

Dipartimento di Scienze dell’Ingegneria, Università di Modena, Modena, Italy

Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 1997 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
AMA. Massarini
A. Massarini
MKM.K. Kazimierczuk
M.K. Kazimierczuk
A new method for predicting the stray capacitance of inductors is presented. The method is based on an analytical approach and the physical structure of inductors. The induc- tor winding is partitioned into basic cells—many of which are identical. An expression for the equivalent capacitance of the basic cell is derived. Using this expression, the stray capacitance is found for both single- and multiple-layer coils, including the presence of the core. The method was tested with experimental measurements. The accuracy of the results is good. The derived expressions are useful for designing inductors and can be used for simulation purposes. HE UPPER operating frequency of every inductor is limited by its self-capacitance. At high frequencies, the response of inductors and transformers is very different from their ac low-frequency response. Skin and proximity effects cause the winding parasitic resistance to increase with the op- erating frequency, and the parasitic capacitance of the winding cannot be neglected either. Therefore, an accurate prediction of the response of inductors that operate at frequencies above several hundred kilohertz, such as, for instance, those used in high-frequency switching power converters, is crucial for the design of high-frequency power circuits. Unfortunately, the parasitic capacitances and resistances are distributed pa- rameters, and their values depend on the operating frequency. Therefore, the theoretical prediction of the frequency response of an inductor is a difficult problem. High-frequency behavior of magnetic components is widely discussed in the literature, but mainly the aspects related to the parasitic ac winding resistances and core losses have been addressed (1)-(6). Some results concerning the stray capacitance of single- and multiple-layer coils have been pre- sented in (7)-(12). These publications offer some interesting physical insights, but the results rely on some experimental data. The purpose of this paper is to present a new method for predicting the stray capacitance of single- or multiple-layer inductors and compare the theoretical and experimental results. The proposed method is based on an analytical approach. It can predict the stray capacitance of an inductor as a function of a few parameters of the geometry and the number of layers.

1 January 1999 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
Gabriele GrandiGabriele Grandi
Gabriele Grandi
MKM.K. Kazimierczuk
M.K. Kazimierczuk
AMA. Massarini
A. Massarini
Ugo ReggianiUgo Reggiani
Ugo Reggiani
This paper presents a method for predicting parasitic capacitances of solenoid HF inductors made of one layer of turns with circular cross sections, uniformly wound around a cylindrical nonconductive core. The method is based on an analytical approach to obtain the turn-to-turn and turn-to-shield capacitances of coils. The influence of the wire insulation is taken into account. An equivalent lumped parallel capacitance is derived. The method was tested by experimental measurements. The calculated and measured values were in good agreement in the considered cases. The derived expressions are useful for designing HF inductors and can also be adopted for modeling and simulation purposes

24 August 2004 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
Gabriele GrandiGabriele Grandi
Gabriele Grandi
MKM.K. Kazimierczuk
M.K. Kazimierczuk
AMA. Massarini
A. Massarini
Ugo ReggianiUgo Reggiani
Ugo Reggiani
GSG. Sancineto
G. Sancineto
We propose a model with frequency-dependent lumped parameters to represent the behavior of laminated iron-core inductors that are used in switching converters, i.e., for excitation frequencies above several kilohertz. The model applies to laminated iron cores with air gaps. We show that the core parameters can be calculated by using the same analytical expressions as those valid for gapless cores if a properly defined equivalent magnetic permeability is introduced instead of the iron sheet permeability. We compare the inductor model parameters calculated as functions of frequency with those obtained by measurements for two test inductors. The behavior of the inductors showed that the effects due to the eddy currents in the laminated iron core and the turn-to-turn and turn-to-core stray capacitances become significant in different frequency ranges.

1 January 1999 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
MKM.K. Kazimierczuk
M.K. Kazimierczuk
GSG. Sancineto
G. Sancineto
Gabriele GrandiGabriele Grandi
Gabriele Grandi
Ugo ReggianiUgo Reggiani
Ugo Reggiani
AMA. Massarini
A. Massarini

24 December 2002
Verified
Conference Paper
Closed access
AMA. Massarini
A. Massarini
MKM.K. Kazimierczuk
M.K. Kazimierczuk
Gabriele GrandiGabriele Grandi
Gabriele Grandi
A method for modeling inductors under high-frequency operation is presented. The method is based on analytical approaches which can predict turn inductances, turn-to-turn and turn-to-core capacitances using physical structure of windings. Turn inductances, turn-to-turn and turn-to-core capacitances of coils are then introduced into suitable lumped parameter equivalent circuits of inductors. The overall inductance and stray capacitance can be obtained through the use of the equivalent circuits. Both single- and multiple-layer inductors are considered. The method was tested with experimental measurements. The accuracy of the results was good in most cases. The derived expressions can be useful for the design of HF inductors and can also be used for simulation purposes.

1 January 1997 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
MKM.K. Kazimierczuk
M.K. Kazimierczuk
AMA. Massarini
A. Massarini