1 June 2006 in Transactions of Nonferrous Metals Society of China
1 January 2005 in Ceramics International
1 June 2012 in Key Engineering Materials
Al2O3 materials were used in a very wide range due to its good mechanical properties and relative low manufacture cost. The corrosion resistance of Al2O3 materials in acid, alkaline and sea water solutions gained more and more attention because many application situations are severe and the working life is shorten due to the corrosion. In this paper, the corrosion behavior of Al2O3 based materials in acid and alkaline solutions was studied and effect of corrosion time on the corrosion behavior of Al2O3 materials was investigated. The microstructure of as prepared Al2O3 materials was characterized by SEM. Possible corrosion process and mechanism was discussed in details. The results reveal that the as prepared Al2O3 materials show better corrosion resistance in alkaline solution than in acid solutions. In both acid and alkaline conditions, the corrosion mainly occurs in the grain boundary. Mass loss increased with increasing corrosion time, while the corrosion rate was decreased.
16 January 2022 in Journal of Materials Science: Materials in Electronics
1 December 2010 in Advanced Materials Research
The synthesis of nanocrystalline pure anatase at low temperature and short time is not an easy achievement, as the synthetic processes generally lead to amorphous, moreover some processes normally require harsh reaction. Uniform nanocrystalline pure anatase has been obtained using tetrabutyl titanate and normal butyl alcohol under microwave irradiation condition at low temperature 120 °C for 3 h. This process simplication will lower production cost and make continuous process possible. It was revealed that the as-synthesized TiO2 products without any heat treatment were uniformly dispersed and granulous single-phase anatase, with the average grain size of 10 nm, by means of XRD and TEM.
14 May 2025 in Environmental Engineering Research
Chelating agent modification and reductant enhancement are effective strategies to improve the narrow working pH and Fe3+/Fe2+ cycle delay of a heterogeneous Fenton system. However, the different mechanisms for the promotional effects between disodium ethylenediaminetetraacetate (EDTA) and hydroxylamine (HA) are rarely reported. Herein, the effects of EDTA and HA on the degradation kinetics of the selected probe compounds were compared in the CoFe2O4/H2O2 system for the first time. This paper found that the EDTA-chelated CoFe2O4 Fenton-like system enhanced the activation rate of H2O2 via reducing the redox potential of Fe2+/Fe3+ and Co2+/Co3+ pairs. The apparent rate constant of methyl orange (MO) in the CoFe2O4/H2O2/HA system was approximately 84-fold higher than that in the CoFe2O4/H2O2 system under the reaction conditions with 1.0 mM of HA and pH 6.4 within 180 min. This result was attributed to the dynamic equilibrium of Fe3+/Fe2+ and Co3+/Co2+ redox cycles after the addition of HA. Based on quenching experiments and electron paramagnetic resonance (EPR), these superior activities are due to the hydroxyl radicals (•OH) and singlet oxygen (1O2) under circumneutral pH, whereas •OH is the major reactive oxygen species (ROS) at pH values 10. The potential mechanism of CoFe2O4/H2O2/EDTA/HA systems was elucidated.