Yoichi Ishizuka

Yoichi Ishizuka

Auto-generated profile, based on publicly available information

Yoichi Ishizuka

Graduate School of Engineering, Nagasaki University, Nagasaki, Nagasaki, JAPAN

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2019
Verified
Conference Paper
Closed access
HWHongyan Wang
Hongyan Wang
YIYoichi Ishizuka
Yoichi Ishizuka
TFTakafumi Fujimoto
Takafumi Fujimoto
We consider the energy efficiency for wireless sensor networks (WSNs) where all the nodes operate on batteries so that the total energy consumption should be minimized. One feasible and effective approach is to treat several individual single-antenna nodes which cooperative at the transmitter and receiver as multiple-antenna, i.e., cooperative MIMO. In this context, for the given bit error rate, we first analyze the total energy consumption under the MPSK modulation scheme by using space time block coding in the cooperative MIMO WSNs. Meanwhile, the upper bound of total energy consumption will be deduced. For both short and long transmission distance, we show the trend of the total energy consumption over the constellation size and obtain the optimal constellation size especially achieving the lowest system energy consumption. Additionally, the total energy consumption can be significantly saved by utilizing cooperative MIMO especially at long transmission distance.

1 June 2008 in 2008 IEEE Power Electronics Specialists Conference
Verified
Conference Paper
Open access
TSTadahiko Sato
Tadahiko Sato
RARyu Araki
Ryu Araki
HOHiroyuki Ota
Hiroyuki Ota
NHNobuhiro Higashi
Nobuhiro Higashi
YIYoichi Ishizuka
Yoichi Ishizuka
HMHirofumi Matsuo
Hirofumi Matsuo
This paper deals with an analysis of the power efficiency of a multi-oscillated current resonant type DC-DC converter. The current resonant type converter employs generally the pulse frequency modulation. For this reason, the magnetizing current through the converter causes not only a power loss under a light load, but also a loss during stand-by. In order to solve these problems, a multi-oscillated current resonant type DC-DC converter has been proposed, and revealed the advantage of its control method which can reduce power loss under light load and keep low switching noise. An analytical relationship of among states, operating mode and efficiency characteristics of this converter are defined. As a result, it was confirmed that for this converter, the output power depends on the voltage of resonant capacitor, and consequently, it is important to determine constants of resonant capacitor and inductance of transformer. The maximum efficiency is 95.4% with the magnetizing inductance 1.8 mH.

26 July 2023 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
TMTakehiro Motomatsu
Takehiro Motomatsu
TKTakahiro Koga
Takahiro Koga
NSNoritaka Shigei
Noritaka Shigei
MYMasahiro Yamaguchi
Masahiro Yamaguchi
AIAtsushi Itagaki
Atsushi Itagaki
YIYoichi Ishizuka
Yoichi Ishizuka
Optimization of magnetic components design, such as power inductors and transformers, is most needed to improve the performance of future power electronics. However, power electronics designers face the problem of not having sufficient magnetic component models available for their designs. In this paper, we propose a method to construct a unique nonlinear magnetic component model using parametric circuit simulation and deep learning.

1 January 2013 in IEEJ Transactions on Industry Applications
Verified
Journal Article
Closed access
KDKazuhide Domoto
Kazuhide Domoto
YIYoichi Ishizuka
Yoichi Ishizuka
TNTamotsu Ninomiya
Tamotsu Ninomiya
SASeiya Abe
Seiya Abe
RSRejeki Simanjorang
Rejeki Simanjorang
MKMasato Kaga
Masato Kaga

1 March 2020
Verified
Conference Paper
Closed access
TUTakeshi Uchida
Takeshi Uchida
YIYoichi Ishizuka
Yoichi Ishizuka
DYDaisuke Yamashita
Daisuke Yamashita
THToshiro Hirose
Toshiro Hirose
KUKazuto Ura
Kazuto Ura
In recent years, a system using renewable energy has attracted attention, and power converters with high power efficiency and low cost are required. Dual Active Bridge (DAB) DC- DC converters are attracting attention because of their high power-efficiency due to Zero Voltage Switching (ZVS) operation over a wide load range. However, when the voltage input/output ratio is different from the turns ratio of the transformer, there is a disadvantage that the ZVS operation cannot be achieved at light loads, and the power efficiency drops. Therefore, this paper proposes a digital control method that can improve power efficiency at light loads regardless of the voltage input/output conversion ratio. In the experiment, it was confirmed that the power efficiency at light loads could be improved by about 10% when the input/output ratio is 200V / 150V, 150V / 100V, and 125V / 75 V.

19 July 2024
Verified
Conference Paper
Open access
KNKengo Nagatani
Kengo Nagatani
NSNoritaka Shigei
Noritaka Shigei
CMChihiro Morita
Chihiro Morita
YIYoichi Ishizuka
Yoichi Ishizuka
HMHiromi Miyajima
Hiromi Miyajima
Weathering steel is a steel material that produces a protective rust layer on the surface of the steel that suppresses the propagation of corrosion. Periodic inspection of the rust condition is necessary to maintain this steel in good condition, and CNN-based methods for evaluating the appearance of rust have been studied. One of the problems in improving the classification accuracy of the CNN is how to prepare the rust images for training. Since it is difficult to collect rust images in the real world, it has been studied to train CNN with rust images generated by GANs. Conventional GANs have the problem that when a large number of images are generated, the generated images are biased toward similar ones. The scope of this paper is to improve the accuracy of CNN using GAN-generated images in classification tasks of rust conditions of weathering steel. The specific objectives of this study are to improve the diversity of images generated by GANs and thereby improve the accuracy of CNNs. To improve image diversity in GAN-based image generation, we propose to use Wasserstein GAN with Gradient Penalty (WGAN-GP), in addition to Conditional GAN (CGAN), and to introduce SSIM (Structural Similarity) and LBP (Local Binary Pattern) as loss functions, in addition to L1 and L2 losses. Then, the images generated by the proposed five types of GANs are applied to the training of CNNs. Comparison between the proposed GANs and the conventional CGAN shows that 1) the proposed GANs can reduce the SSIM similarity of the generated images by up to 1/4, and 2) in the classification of three classes of rust images, the use of the generated images of the proposed GANs can improve the F1 score by up to about 4%pt. Overall analysis shows that WGAN-GP-based is better than CGAN-based and that the newly introduced SSIM, LBP, L1 and L2 losses improve both similarity and classification accuracy.