The accumulation of electronic waste (e-waste) on the ground leads to environmental pollution with toxic metal ions, which subsequently harms all living organisms. Many countries still use hydrometallurgical or manual methods to extract silver ions from e-waste. These methods are unsustainable and highly toxic; therefore, it becomes necessary to introduce new environmentally compatible methods for separating valuable components from objects of various compositions. This article proposes an environmentally compatible method for the extraction of silver ions from multicomponent systems using poly(N-thiocarbamoyl‑3-aminopropylsilsesquioxane). The sorbent surface was studied by Fourier-transform infrared spectroscopy using an attenuated total internal reflection accessory. The concentration of grafted thiourea groups is 1.39 mmol/g according to elemental analysis. It has been determined that this sorbent is capable of quantitatively extracting silver ions in the pH range from 0 to 6 at a concentration of silver ions in the initial solution of 1·10–4 mol/dm3; the static sorption capacity for silver ions under experimental conditions reaches 1.22 mmol/g. When sorption is carried out in dynamic mode, the value of the dynamic capacity before breakthrough is 0.046 mmol/g, and the value of the total dynamic capacity for silver ions is 0.132 mmol/g. The highest desorption (71–78 %) is achieved using sulfuric acid solutions with a thiourea concentration gradient.
Sorption properties of poly(3-aminopropylsilsesquioxanes) modified with thiourea groups were studied to predict the possibility of using poly(n-thiocarbamoyl-3-aminopropylsilsesquioxanes) (TCPS) in separation and concentration techniques. The sorbents were synthesized by the sol-gel method followed by solid-phase modification using ammonium thiocyanate or thiosemicarbazide as modifiers. It was established that sorbents with the highest content of thiocarbamide functional groups (modified with ammonium thiocyanate) enabled quantitative and selective recovery of Ag (I) from strongly acidic solutions. The degree of Ag (I) recovery slightly decreases at pH>5, which is associated with increasing competitive sorption of Cu (II), Ca (II), Mg (II), Mn (II) and Fe (III). The highest recovery of Ag (I) for TCPS-0.63 and TCPS-0.68 was achieved at pH ranging from 4 to 8 (degree of recovery was 55–68% (TCPS-0.63); 21–26% (TCPS-0.68 )); at the same time, there was a predominance of competitive sorption of Ca (II), Mg (II), Mn (II), and Fe (III). Based on the aforementioned, it can be concluded that the sorbents modified with ammonium thiocyanate are characterized by high concentration of attached thiocarbamide groups that make them suitable for the selective recovery of Ag (I) ions from multicomponent solutions at pH 1–2.
Изучено влияние минерального состава воды на результаты определения кремния методом атомно-абсорбционной спектрометрии высокого разрешения с источником непрерывного спектра (НИ-ВР-ЭТААС) при анализе образцов природных вод из разных регионов РФ и модельных растворов. Зафиксирована низкая степень атомизации кремния при анализе проб со сложной матрицей на фоне интенсивного сигнала поглощения матричных компонентов. Установлена причина неселективного поглощения химическими соединениями основы пробы на примере воды с самым сложным составом и общей жесткостью порядка 2000 °Ж. Доказано влияние растворимых солей Ca и Mg в присутствии макрокомпонентов — ионов щелочных металлов (K и Na) — на определение кремния в воде. Показано, что при значениях общей жесткости менее 15 °Ж отсутствует зависимость аналитического сигнала от содержания матричных компонентов. Сделано предположение о сильном влиянии соединений кальция на определение аналита за счет образования карбидного покрытия на поверхности графитовой печи, появления «эффекта памяти» и увеличения фонового сигнала при последующих циклах атомизации. При определении кремния наилучшие результаты получены в присутствии вольфрама, железа, магния и палладия в качестве химических модификаторов. Для снижения уровня фонового поглощения при электротермической атомизации минеральной воды использовали разбавление раствора пробы. Предложены условия устранения влияния матричных компонентов для реальных проб минеральной воды и растворов сравнения. Разработана методика определения растворенных форм кремния в пробах воды со сложной матрицей. Правильность результата определения кремния в пробах природной подземной воды в случае сильного матричного эффекта подтверждена с помощью анализа независимым методом.