Hydraulic fracture propagation is hard to predict due to natural joints and crustal stress. This process may lead to uncontrollable changes in hydrogeological conditions. Therefore, prediction and control of fracture propagation are paramount to permeability increase in ore-bearing reservoir. The coupled fluid-solid model was utilized to predict the hydraulic fracture propagation in low-permeability sandstone of a uranium mine. For this study, the model was modified to allow fractures to propagate randomly by using the cohesive zone method. The simulation was developed on a three-step process. First, geological data required to run the model, including crustal stress, strength and permeability, were assembled. Next, fracture propagation under different conditions of stress and injection volume were simulated. In the final step, experimental data required to validate the model were obtained. The simulation results indicate that the principal stress, distribution and orientation of natural fracture have vital influence on fracture propagation and induced complex fracture network. This work provides a theoretical basis for the application of hydraulic fracture in low-permeability sandstone reservoir and ensures the possibility to predict the generation of complex fracture network.
The temporal permeability and damage evolutions of low-permeability sandstone cores during triaxial and long-term dissolution experiments were measured using a triaxial-flow system. Three triaxial experiments were performed on sandstone cores having initial permeability ranging from to . Two sets of long-term dissolution experiments were conducted on cracked sandstone cores. All dissolution experiments were performed at room temperature and using a 10 g/L H2SO4 and 0.2 g/L H2O2 input solution. Permeability evolution was determined using Darcy’s law. The cores experienced an average increase of 25% in permeability in the dissolution experiment and 900%~1500% increase at the end of the experiment. The dissolution was fairly homogeneous during the long-term experiments whether on the 1 mm scale or the 10 μm scale. The relationship between damage and permeability was speculated and its correlation coefficient has been proved to be close to 1. These results suggest that hydraulic fracturing works well in permeability increase in low-permeability sandstone reservoir.
To investigate the creep behavior of deep‐buried hard rocks under various initial damage conditions, standard dolomite specimens were subjected to conventional triaxial compression and creep tests under a confining pressure of 30 MPa. The study analyzed the axial creep characteristics, total creep duration, deformation modulus, and failure modes of dolomite with different initial damage levels. Subsequently, a novel nonlinear creep constitutive model for hard rocks that incorporates initial damage was developed. The findings are as follows: (1) Under incremental loading, the axial strain of dolomite with varying initial damage exhibited a stepwise increase. The axial instantaneous strain increased nearly linearly with stress levels, and this strain intensified with greater damage at equivalent stress levels. (2) Dolomites with varying degrees of damage all experienced four distinct phases: instantaneous deformation, decelerating creep, steady‐state creep, and accelerating creep. Increased damage corresponded to shorter total creep durations and reduced deformation moduli. At a loading stress of 80%, the total creep duration and deformation modulus of the damaged specimens decreased by 50.39% and 24.18%, respectively. (3) The creep failure mode of dolomite shifted from a predominant shear failure to a more complex combination of shear and tensile failure as damage increased. (4) This model accurately captures the three characteristic creep stages and the influence of initial damage on creep failure stress, offering a fresh perspective for the study of triaxial creep mechanical properties of dolomite with different initial damage levels under high‐stress conditions.