Somnath Dattatray Shinde

Somnath Dattatray Shinde

Auto-generated profile, based on publicly available information

Somnath Dattatray Shinde

Department of Chemical & Biomolecular Engineering, University of Tennessee, Knoxville, USA

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 April 2018 in Green Chemistry
Verified
Journal Article
Closed access
PDF file
SSSomnath D. Shinde
Somnath D. Shinde
XMXianzhi Meng
Xianzhi Meng
RKRajeev Kumar
Rajeev Kumar
Arthur RagauskasArthur Ragauskas
Arthur Ragauskas
The formation of lignin-like structures by the degradation primarily of plant polysaccharides has been observed after the severe thermochemical acidic pretreatment of lignocellulosic biomass.

7 September 2017 in Green Chemistry
Verified
Journal Article
Closed access
PDF file
ZLZhi-Hua Liu
Zhi-Hua Liu
MOMichelle L. Olson
Michelle L. Olson
SSSomnath Shinde
Somnath Shinde
XWXin Wang
Xin Wang
NHNaijia Hao
Naijia Hao
JYJoshua S. Yuan
Joshua S. Yuan
Lignocellulosic biorefineries have gained much attention worldwide as a potential solution to the challenges of energy demand and global climate change. However, the industrial implementation of biorefineries has been hindered by low fermentable sugar yields and low lignin processability. Combinatorial pretreatments with a low holding temperature were investigated in an effort to synergistically improve the carbohydrate output and lignin processability from corn stover. Upon combinatorial pretreatment with 1% H2SO4 for 30 min followed by 1% NaOH for 60 min at 120 °C, glucan and xylan conversion increased by 11.2% and 8.3% respectively relative to single pretreatment. This combinational pretreatment removed the amorphous portion, disrupted the rigid structure, and increased the water holding capacity of corn stover, thus increasing the hydrolysis performance. With whole fractionation by combinatorial pretreatment, glucose and xylose yields were 88.4% and 72.6%, respectively, representing increases of 10.0% and 8.1%. The lignin yield was 19.7% in the solid residue and 77.6% in the liquid stream, which increased by 33.4%. When grown in fed-batch fermentation mode, a record level of polyhydroxyalkanoate (PHA) concentration (1.0 g l−1) was obtained using lignin as a carbon source by Pseudomonas putida KT2440. Lignin characterization results showed that combinatorial pretreatment increased the G- and H-lignin content, reduced the β–β and β-O-4 groups, and fractionated more aromatic monomers, thus facilitating lignin processability into PHA. These results highlighted the use of combinational pretreatment at a low holding temperature as a means to synergistically maximize the carbohydrate output and lignin processability, which provides a unique set of features to improve the biorefining performance.

29 June 2018 in Green Chemistry
Verified
Journal Article
Open access
PDF file
FGFlorence J. V. Gschwend
Florence J. V. Gschwend
Francisco MalaretFrancisco Malaret
Francisco Malaret
SSSomnath Shinde
Somnath Shinde
ABAgnieszka Brandt-Talbot
Agnieszka Brandt-Talbot
Jason HallettJason Hallett
Jason Hallett
Deconstruction with low-cost ionic liquids (ionoSolv) is a promising method to pre-condition lignocellulosic biomass for the production of renewable fuels, materials and chemicals. This study investigated process intensification strategies for ionoSolv pretreatment of Miscanthus × giganteus with the low-cost ionic liquid triethylammonium hydrogen sulfate ([TEA][HSO4]) in the presence of 20 wt% water, using high temperatures and a high solid to solvent loading of 1 : 5 g/g. The temperatures investigated were 150, 160, 170 and 180 °C. We discuss the effect of pretreatment temperature on lignin and hemicellulose removal, cellulose degradation and enzymatic saccharification yields. We report that very good fractionation can be achieved across all investigated temperatures, including an enzymatic saccharification yield exceeding 75% of the theoretical maximum after only 15 min of treatment at 180 °C. We further characterised the recovered lignins, which established some tunability of the hydroxyl group content, subunit composition, connectivity and molecular weight distribution in the isolated lignin while maintaining maximum saccharification yield. This drastic reduction of pretreatment time at increased biomass loading without a yield penalty is promising for the development of a commercial ionoSolv pretreatment process.

15 November 2018 in Green Chemistry
Verified
Journal Article
Closed access
PDF file
ZLZhi-Hua Liu
Zhi-Hua Liu
NHNaijia Hao
Naijia Hao
SSSomnath Shinde
Somnath Shinde
YPYunqiao Pu
Yunqiao Pu
XKXiaofeng Kang
Xiaofeng Kang
JYJoshua S. Yuan
Joshua S. Yuan
Sustainable biorefinery heavily depends on the generation of value-added products, particularly from lignin. Despite considerable efforts, the production of fungible lignin bioproducts is still hindered by the poor fractionation and low reactivity of lignin. To address these challenges, the sequential organosolv fragmentation approach (SOFA) using ethanol plus different-stage catalysts was explored to selectively dissolve lignin for producing multiple uniform lignin streams, and to tailor its chemistry and reactivity for fabricating lignin nanoparticles (LNPs) with desired quality features. In a biorefinery concept, the carbohydrate output is taken into consideration. SOFA significantly increased the glucose and xylose yields, suggesting an improved monomer-sugar release. The fractionated lignin was used to fabricate LNPs via self-assembly. Although these LNPs were derived from the same substrate, they exhibited different properties. The effective diameter almost followed the order of stage 1, stage 3, and stage 2 in each SOFA, and the smallest effective diameter was approximately 130 nm from SOFA using ethanol plus sulfuric acid. The polydispersity index and zeta potential were less than 0.08 and −50 mV, respectively, suggesting good uniformity and stability of the LNPs. Lignin characterization results suggested that SOFA using ethanol plus sulfuric acid produced high-molecular-weight lignin, decreased S/G ratio, and β-O-4 and β–β linkage abundance, yet produced the condensed lignin and enhanced its hydrophobicity. More importantly, it exposed more phenolic OH groups and enhanced the stability of LNPs, likely due to the hydrogen bond networks. Together with enriched COOH groups, it promoted the formation of electrical double layers and increased the zeta potential of LNPs. As a result, by tailoring the lignin chemistry using SOFA to enhance the self-assembling process, high-quality LNPs of a spherical shape, small effective diameters, and good stability have been fabricated, which represents a sustainable means for upgrading the low-value lignin and thus contributes to the profitability of biorefineries.

3 June 2019 in Sustainable Energy & Fuels
Verified
Journal Article
Closed access
PDF file
ZLZhi-Hua Liu
Zhi-Hua Liu
SSSomnath Shinde
Somnath Shinde
SXShangxian Xie
Shangxian Xie
NHNaijia Hao
Naijia Hao
FLFurong Lin
Furong Lin
JYJoshua S. Yuan
Joshua S. Yuan
Lignin valorization is essential for a sustainable and economically viable biorefinery. Despite the recent efforts, it is still unclear how the reactivity of native lignin can be improved by pretreatment in a biorefinery and how different components in biorefinery residue especially residual sugar contribute to bioconversion in biorefineries. In the present study, co-utilization of lignin and limited glucose was first evaluated and proved to facilitate lignin conversion and polyhydroxyalkanoate (PHA) production. A new integrated biorefinery was then designed to cooperatively valorize lignin and residual sugar for improving the PHA yield and utilization efficiency of biorefinery residue. By the design of integrated biorefinery, the glucose and xylose yield were 91% and 73%, respectively, which increased by 18% and 12% compared with that only using sodium hydroxide pretreatment. Approximately 85% of the lignin was dissolved into a liquid stream with the integrated biorefinery, corresponding to an increase of 69% compared with that only using sodium hydroxide pretreatment. More than 70% of the residual sugar was released from the biorefinery residue, producing the soluble lignin stream that contains both lignin and residual sugar for synergistic bioconversion. Bioconversion of the soluble lignin stream with Pseudomonas putida KT2440 produced 1.5 g l−1 PHA, representing the record titer of PHA from biorefinery residue. The lignin characterization results from nuclear magnetic resonance and gel-permeation chromatography showed that the integrated process significantly reduced the lignin molecular weight, broke down more β-O-4 and β-5 linkages, and enriched the H-lignin content. Alongside the increased residual sugar concentration, the bioconversion performance of soluble lignin to PHA was significantly improved. Overall, the integrated biorefinery increased the fermentable sugar yield and improved the PHA production from biorefinery waste by cooperative valorization of lignin and residual sugar, which shows potential advantages for biorefinery sustainability.

28 December 2018 in ACS Sustainable Chemistry & Engineering
Verified
Journal Article
Closed access
ZLZhi-Hua Liu
Zhi-Hua Liu
NHNaijia Hao
Naijia Hao
SSSomnath Shinde
Somnath Shinde
MOMichelle L. Olson
Michelle L. Olson
SBSamarthya Bhagia
Samarthya Bhagia
JYJoshua S. Yuan
Joshua S. Yuan