1 January 1994 in Semiconductor Science and Technology
Hydrogenated amorphous silicon-carbon alloy films have been prepared by simultaneous RF reactive magnetron sputtering of silicon and graphite in an H2 + Ar gas mixture. Infrared and Raman measurements have been performed for samples prepared under different conditions. It is found that the intensity of the band related to silicon-carbon vibrations at approximately 760 cm-1 in the in spectra decreases with increasing quantity of hydrogen in the gas mixture. A model is used which describes the deposition as a three-stage process: sputtering of the target, transport of the sputtered material in the plasma and film growth processes on the substrate. Analysis of the experimental data allows one to conclude that for a carbon content in the films below 20% carbon is mainly incorporated as carbon-related clusters (CH3) and for a carbon content above 20% hydrogen-assisted desorption of CH3 and/or CH4 groups takes place on the substrate, which significantly lowers the carbon content in the films.
6 November 2024 in Journal of Physics D: Applied Physics
Multi-material, multi-layered systems such as AlGaN/GaN high electron mobility transistors (HEMTs) contain residual mechanical stresses that arise from sharp contrasts in device geometry and materials parameters. These stresses, which can be either tensile or compressive, are difficult to detect and eliminate because of their highly localized nature. We propose that their high-stored internal energy makes potential sites for defect nucleation sites under radiation, particularly if their locations coincide with the electrically sensitive regions of a transistor. In this study, we validate this hypothesis with molecular dynamic simulation and experiments exposing both pristine and annealed HEMTS to 2.8 MeV Au+3 irradiation. Our unique annealing process uses mechanical momentum of electrons, also known as the electron wind force (EWF) to mitigate the residual stress at room temperature. High-resolution transmission electron microscopy and cathodoluminescence spectra reveal the reduction of point defects and dislocations near the two-dimensional electron gas region of EWF-treated devices compared to pristine devices. The EWF-treated HEMTs showed relatively higher resilience with approximately 10% less degradation of drain saturation current and ON-resistance and 5% less degradation of peak transconductance. Both mobility and carrier concentration of the EWF-treated devices were less impacted compared to the pristine devices. Our results suggest that the lower density of nanoscale stress localization contributed to the improved radiation tolerance of the EWF-treated devices. Intriguingly, the EWF is found to modulate the defect distribution by moving the defects to electrically less sensitive regions in the form of dislocation networks, which act as sinks for the radiation induced defects and this assisted faster dynamic annealing.
1 March 1999 in Journal of Non-Crystalline Solids