The Creation of a Strong Magnetic Field by Means of Large Magnetic Blocks from NdFeB Magnets in Opposing Linear Halbach Arrays magnetic field;permanent magnets;NdFeB magnets;Halbach arrays; The article presents the results and findings obtained through the assembly of opposing linear Halbach arrays from two magnet layers using large magnetic blocks from permanent NdFeB magnets, especially concerning the distribution of magnetic induction in an air gap. The use of these large blocks has led to a significant expansion of the area of magnetic field with a substantially higher value of magnetic induction in comparison with similar linear Halbach arrays composed of small magnets. The paper also discusses the determined dependences of magnetic induction on the parameters of the x, y, z coordinate system and indicates the possibilities of achieving an even stronger magnetic field in a larger volume of an air gap for application for instance in equipment for magnetic separation of raw materials, in instrument technologies and in other areas.
The article presents the results of the experimental implementation of separate and opposing linear structures of different sizes using NdFeB permanent magnets. It focuses on the distribution of the resulting magnetic induction. For both separate and opposing structures, composed of two layers of magnets, the magnetic induction attained was much more affected by changes in the width of the central magnet than by the increasing width of side magnets. When the width of the central magnet in either of the two opposing double-layer Halbach structures was increased approximately three times, the area of the uniform magnetic field attained in the middle of a 20-mm-wide air gap was roughly three times bigger with only ca 7% lower induction in comparison with opposing Halbach structures of optimized dimensions. These make it possible to generate the maximum magnetic field in the middle of the air gap, but only in a narrow band.
The article presents the principle of a relatively small device that makes it possible to generate a strong magnetic field in an air gap without electrical energy consumption. It describes the implemented design of this device, the method of the assembly of opposing linear arrays from two NdFeB magnet layers, its advantages, the possible ways of increasing the parameters further and its application in various areas.