1 July 2020 in Journal of Renewable and Sustainable Energy
The wind-energy (WE) industry relies on numerical weather prediction (NWP) forecast models as foundational or base models for many purposes, including wind-resource assessment and wind-power forecasting. During the Second Wind Forecast Improvement Project (WFIP2) in the Columbia River Basin of Oregon and Washington, a significant effort was made to improve NWP forecasts through focused model development, to include experimental refinements to the High Resolution Rapid Refresh (HRRR) model physics and horizontal grid spacing. In this study, the performance of an experimental version of HRRR that includes these refinements is tested against a control version, which corresponds to that of the operational HRRR run by National Oceanic and Atmospheric Administration/National Centers for Environmental Protection at the outset of WFIP2. The effects of horizontal grid resolution were also tested by comparing wind forecasts from the HRRR (with 3-km grid spacing) with those from a finer-resolution HRRR nest with 750-m grid spacing. Model forecasts are validated against accurate wind-profile measurements by three scanning, pulsed Doppler lidars at sites separated by a total distance of 71 km. Model skill and improvements in model skill, attributable to physics refinements and improved horizontal grid resolution, varied by season, by site, and during periods of atmospheric phenomena relevant to WE. In general, model errors were the largest below 150 m above ground level (AGL). Experimental HRRR refinements tended to reduce the mean absolute error (MAE) and other error metrics for many conditions, but degradation in skill (increased MAE) was noted below 150 m AGL at the two lowest-elevation sites at night. Finer resolution was found to produce the most significant reductions in the error metrics.
1 October 2005 in Journal of the Atmospheric Sciences
Research aircraft observations from the 8–9 December 2001 case of the second phase of the Improvement of Microphysical Parameterization through Operational Verification Experiment (IMPROVE-2) describe the evolution of a wide cold-frontal rainband (WCFR) during its eastward advance from the Pacific coastline to a point 200 km inland over the Cascade Mountains of Oregon. This analysis has two objectives: first, to illustrate the rapid weakening of the circulation associated with a landfalling WCFR and the relationship of these changes to terrain-induced airflow modifications, and second, to quantify the degree to which this weakening impacted cloud microphysical properties such as liquid water content, ice particle concentrations, and precipitation rate. The kinematic structure of the WCFR is detailed using Doppler radar observations from a NOAA P-3 aircraft, while some concomitant cloud microphysical properties are documented using flight-level measurements from the University of Washington Convair-580 aircraft. An accompanying the fifth-generation Pennsylvania State University–National Center for Atmospheric Research (PSU–NCAR) Mesoscale Model (MM5) control simulation (nested to a horizontal resolution of 4 km over the IMPROVE-2 domain) provides a mesosynoptic context and thermodynamic information to complement the aircraft observations. To the authors’ knowledge, this case study represents the most complete documentation obtained to date of the rapid modifications that may occur when a frontal rainband progresses from coastal waters into a region of prominent terrain.
1 March 2008 in Journal of the Atmospheric Sciences
Previous model simulations indicate that in stratiform precipitation, the precipitation rate can increase by 7% in the melting layer through direct condensation onto melting snow and the resultant cooled rain. In the present study, a model simulation of stratiform precipitation in a wide cold frontal rainband indicates that the precipitation rate can also increase by 5% in the melting layer through accretion, by melting snow and rain, of additional cloud water produced by the latent cooling of the ambient air associated with melting snow. The contribution of the combined processes, and therefore the additional precipitation gained through the latent cooling of melting snow within the melting layer, may contribute as much as 10% to the precipitation rate in stratiform precipitation.