1 March 2022 in Optics & Laser Technology
11 February 2021 in Structural Health Monitoring
Quality assurance of adhesively bonded joints is of vital importance if their benefits are to be exploited across a wide range of industrial applications. A novel lightweight, low-cost, non-invasive embedded sacrificial sensor is proposed, capable of detecting damage within an adhesively bonded joint, which could also be used in a laminated composite structure. The sensor operation uses changes in electrical resistance, increasing as the sensing material area diminishes with damage progression. Initial tests prove the sensor concept by showing that the electrical resistance of the sensor increases proportionally with material removal, mimicking the sensor operation. Thermography is used to verify the current flow through the sensor and that any localised heating caused by the sensor is minimal. Short beam interlaminar shear strength (ILSS) tests show that embedding sensors in a composite laminates did not cause a reduction in material interfacial structural performance. Finally, the in situ performance of the sensor is demonstrated in quasi-static tensile tests to failure of adhesively bonded single lap joints (SLJs) with sensors embedded in the bond line. Prior to crack initiation, an electrical response occurs that correlates with increasing applied load, suggesting scope for secondary uses of the sensor for load monitoring and cycle counting. Crack initiation is accompanied by a rapid increase in electrical resistance, providing an indication of failure ahead of crack propagation and an opportunity for timely repair. As the crack damage propagated, the electrical response of the sensor increased proportionally. The effect of the sensor on the overall structural performance was assessed by comparing the failure load of joints with and without the embedded sensor with no measurable difference in ultimate strength. The research presented in the article serves as an important first step in developing a simple yet promising new technology for structural health monitoring with numerous potential applications.
21 December 2018 in Measurement Science and Technology
The maximum depth for which a defect of a given size can be detected in thermographic inspections is known as the ‘probing depth’. For materials such as polymer composites, with low through-thickness thermal diffusivity, inspections are limited to thin materials or near surface inspection. With the aim of improving probing depth, the paper describes how established signal processing techniques are adapted for thermographic inspections. The procedures are implemented for both pulse thermography and pulse phase thermography inspections of laminated composite materials and sandwich structures. It is demonstrated that the adaptation significantly improves the probing depth, identifying defects that could not be identified using existing procedures. The applicability of the new approaches is discussed, paying particular attention to systematic and random errors resulting from equipment setup. Simple and efficient compensation methods to reduce the effect these errors are presented.
27 June 2026 in SSRN Electronic Journal
JBJanice M. Dulieu Barton
+2
Accelerating delivery of fuel-efficient aircraft is a significant enabler for aerospace emission reduction, however, aircraft structure verification currently relies on slow and expensive experimental testing. Bayesian model calibration, which integrates data from numerical models and experiments while accounting for uncertainties in model inputs, observation errors, and model discrepancies, can be used to inform predictions of structural behaviour vital for the design and certification of composite aircraft components. This approach can, however, be prohibitively computationally expensive when applied to large datasets with high temporal and spatial resolution, such as Finite Element (FE) model outputs or Digital Image Correlation (DIC) point clouds. A new methodology is proposed which overcomes this limitation to enable computationally tractable calibration using full displacement vector field output from FE models and DIC across multiple load increments. A demonstration case is presented that utilises a combined dataset of displacements obtained from DIC using images captured during compression tests on a carbon fibre composite C-spar, and from an FE model that accounts for uncertainties in the boundary conditions, geometry, and material properties. Uncertainty in these inputs is reduced using Bayesian inference to learn about the ”true” test conditions. Quantitative full-field comparisons are made between the DIC and updated model displacements enabling clearer verification of the model physics, most significantly, by reducing the boundary condition uncertainty to account for rigid body motion. This capability constitutes the first steps towards verified virtual testing at structurally relevant length scales, which in turn has the potential to accelerate structural verification, without compromising safety.
2 November 2026 in Composites Part B: Engineering
JDJanice M. Dulieu-Barton
+2