The crystallographic properties of two titanium dioxide (TiO2) photocatalysts, P25, and commercial C1-TiO2 reactive grade, were analyzed by X-ray diffraction (XRD) and the band-gap was calculated with UV–Vis spectrometry with integration sphere. Then, their performance was tested in the degradation of 6-mercaptopurine (6-MP) by heterogeneous photocatalysis with solar radiation under different pH conditions and the addition of hydrogen peroxide (H2O2); the degradation efficiency was monitored by UV–Vis spectrophotometry. The XRD analysis showed that both photocatalysts studied have anatase phase, while only P25 contains rutile; the band gap values were lower, in both catalysts, than those reported for catalysts obtained by the sol-gel method. With both photocatalysts, degradation experiments showed efficiency greater than 98% in experiments in the presence of H2O2 regardless of pH. The properties of the photocatalysts, along with the data obtained from the experimentation, helped determine the best semiconductor for the degradation of 6-MP with these operating conditions in this work.
Over the years, there has been an increase in the consumption of drugs, particularly antibiotics. Amoxicillin (AMX) is considered one of the most widely used antibiotics, causing resistance in microorganisms in the ecosystem where it is found. Additionally, it has been cataloged among the drugs under surveillance by the European Commission since 2020. The present work studies the efficiency of AMX degradation by photolysis and heterogeneous solar photocatalysis processes under different reaction pH levels (3.5, 4.15, 7 and 9) and observing the influence of different doses of H2O2 (nil and 4 mM), as an oxidizing agent. TiO2 P25 was used as photocatalyst, impregnated in glass supports of 0.1 and 1 m2 in flat plate reactors (FPR). A 2 × 2 × 4 statistical analysis carried out after repeated measurements to determine the relationship between the different parameters involved (process, H2O2 dose, and pH). The kinetics of the AMX degradation reaction showed the best rate constant (KphC = 0.10 min−1) under acidic medium conditions (pH 4.15), without addition of H2O2, and by heterogeneous photocatalysis when using a 1 m2 FPR to achieve 100% COD removal. ANCOVA showed significant differences (p < 0.05) in the use of H2O2 for the first minutes of the reaction and in the different FPR surfaces.
16 April 2024 in International Journal of Hydrogen Energy