1 January 2024 in APL Photonics
The primary challenge for long-wavelength infrared (λ = 8–13 µm) detection has long been the mitigation of dark current while achieving a high conversion efficiency of optical to electrical signals. Often overlooked is the bandwidth of detector response, despite several existing and expected future long-wave infrared high bandwidth applications. Here, we demonstrate ultra-fast response times in long-wave infrared detectors leveraging ultra-thin absorbers. The time response of the detectors is characterized using mid-infrared femtosecond pulses generated by an optical parametric amplifier, as a function of the device temperature and operating bias, as well as excitation wavelength. An equivalent circuit model for the detectors is presented and compared to our experimental results with excellent agreement. We demonstrate detector impulse response times of 3.5 GHz). Spectral response measurements confirm that the detectors have a resonant cavity mode enhanced response in the long-wave infrared, peaking at 10.2 µm. The presented detectors offer a potential solution for a range of high-frequency applications in the long-wave infrared.
8 March 2023 in Journal of Applied Physics
We demonstrate high-speed mid-wave infrared photoconductive detectors leveraging a lattice-mismatched, epitaxially grown InSb absorber material patterned with nanometer-scale hole arrays. We show that the nano-scale hole patterns allow for post-growth control over the detector response time by introducing recombination surfaces to increase non-radiative recombination. The photoconductive pixels are integrated into a microwave coplanar waveguide for high frequency characterization. The detector response is characterized as a function of temperature and hole-array dimensions. We show a detector response with characteristic time scales of tens of picoseconds and bandwidths up to 7 GHz at room temperature. The presented detectors offer a mechanism for engineering response times in long wavelength detectors for potential applications in high-speed sensing/imaging, free-space communication, ranging, or dual-comb spectroscopy.
8 February 2016 in Applied Physics Letters
We demonstrate a room-temperature semiconductor-based photodetector where readout is achieved using a resonant radio-frequency (RF) circuit consisting of a microstrip split-ring resonator coupled to a microstrip busline, fabricated on a semiconductor substrate. The RF resonant circuits are characterized at RF frequencies as function of resonator geometry, as well as for their response to incident IR radiation. The detectors are modeled analytically and using commercial simulation software, with good agreement to our experimental results. Though the detector sensitivity is weak, the detector architecture offers the potential for multiplexing arrays of detectors on a single read-out line, in addition to high speed response for either direct coupling of optical signals to RF circuitry, or alternatively, carrier dynamics characterization of semiconductor, or other, material systems.
10 May 2018 in Nanotechnology
Plasmon based field effect transistors (FETs) can be used to convert energy induced by incident optical radiation to electrical energy. Plasmonic FETs can efficiently detect incident light and amplify it by coupling to resonant plasmonic modes thus improving selectivity and signal to noise ratio. The spectral responses can be tailored both through optimization of nanostructure geometry as well as constitutive materials. In this paper, we studied various plasmonic nanostructures using gold for a wideband spectral response from visible to near-infrared. We show, using empirical data and simulation results, that detection loss exponentially increases as the volume of metal nanostructure increases and also a limited spectral response is possible using gold nanostructures in a plasmon to electric conversion device. Finally, we demonstrate a plasmon FET that offers a broadband spectral response from visible to telecommunication wavelengths.