Polymer electrolyte fuel cells (PEFCs) are a promising replacement for the fossil fuel–dependent automotive and energy sectors. They have become increasingly commercialized in the last decade; however, significant limitations on durability and performance limit their commercial uptake. Catalyst layer (CL) design is commonly reported to impact device power density and durability; although, a consensus is rarely reached due to differences in testing conditions, experimental design, and types of data reported. This is further exacerbated by aspects of CL design such as catalyst support, proton conduction, catalyst, fabrication, and morphology, being significantly interdependent; hence, a wider appreciation is required in order to optimize performance, improve durability, and reduce costs. Here, the cutting‐edge research within the field of PEFCs is reviewed, investigating the effect of different manufacturing techniques, electrolyte distribution, support materials, surface chemistries, and total porosity on power density and durability. These are critically appraised from an applied perspective to inform the most relevant and promising pathways to make and test commercially viable cells. This holistic view of the competing aspects of CL design and preparation will facilitate the development of optimized CLs, especially the incorporation of novel catalyst support materials.
Lithium sulfur (Li-S) batteries have great potential as a successor to Li-ion batteries but their commercialization has been complicated by a multitude of issues stemming from their complex multi-phase chemistry. In-situ X-ray tomography investigations enable direct observations to be made about a battery, providing unprecedented insight into the microstructural evolution of the sulfur cathode and shedding light on the reaction kinetics of the sulfur phase. Here, for the first time, the morphology of a sulfur cathode was visualized in 3D as a function of state of charge at high temporal and spatial resolution. Whilst elemental sulfur was originally well dispersed throughout the uncycled cathode, subsequent charging resulted in the formation of sulfur clusters along preferred orthogonal orientations in the cathode. The electrical conductivity of the cathode was found not to be rate-limiting, suggesting the need to optimize the loading of conductive carbon additives. The carbon and binder domain, and surrounding bulk pore phase were visualized in the in-situ cell, and contrast changes within both phases were successfully extracted. The applications of this technique are not limited to microstructural and morphological characterization, and the volumetric data can serve as a valuable input for true 3D computational modelling of Li-S batteries.
1 December 2019 in Energy Conversion and Management