Spray cooling is a highly effective method of heat removal that has broad practical applications, including use in modern cooling systems designed for microelectronics and microchips. It is known that spray cooling performance is influenced by a huge number of factors. This experimental research is devoted to the study of the influence of a liquid flow rate in the range of 15.1–24.2 cm3/s, heat flux up to 6.4 MW/m2, and nozzle-to-surface distance on the heat transfer rate in non-boiling mode and the distribution of the local temperature of the heat exchange surface during spray cooling. It is shown that the heat transfer coefficient weakly depends on the heat flux for all studied nozzle-to-surface distances. It is demonstrated that the nozzle-to-surface distance has a significant influence on the heat transfer and the temperature distributionon the heating surface during spray cooling in non-boiling mode. At the same time, there is an optimal distance at which the maximum heat transfer rate and uniformity of the temperature are achieved. Criteria and a ratio for determining the optimal distance from the spray nozzle to the heated surface are proposed.
Measuring the wave characteristics of a film of liquid by different methods enables one to improve the reliability of data and obtain new information about the process being studied. Along with the...
We have experimentally studied the heat transfer under conditions of pulsed multinozzle jet spray impact onto a vertical surface. The working coolant fluid was aqueous ethanol solution in a range of concentrations K1 = 0–96%. The duration of spray pulses was τ = 2, 4, and 10 ms at a repetition frequency of 10 Hz. The maximum heat transfer coefficient was achieved at an ethanol solution concentration within 50–60%. The thermal efficiency of pulsed spray cooling grows with increasing ethanol concentration and decreasing jet spray pulse duration.
A large-scale experimental setup is designed to study the hydrodynamic parameters and the mass-transfer efficiency in a countercurrent flow of mixtures of Freon R21 and Freon R114 on structured packings in a column 0.9 m in diameter. The study deals with the local and integral parameters of separation of the mixture, the degrees of nonuniformity of the flow rates and concentration distributions of the liquid and vapor phases over a cross section and on the column wall, and the pressure difference while varying the number of packing layers and their rotation angle. The mass-transfer processes while independently varying the liquid and vapor flow rates over wide ranges are also investigated. Experimental data are presented to illustrate the effect of the operating parameters on the height of an equivalent theoretical plate, the relative pressure difference, and the distributions of the local parameters of the flows.