Marco Crepaldi

Marco Crepaldi

Auto-generated profile, based on publicly available information

Marco Crepaldi

Italian Institute of Technology

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 August 2011 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
MCMarco Crepaldi
Marco Crepaldi
CLChen Li
Chen Li
JFJorge Fernandes
Jorge Fernandes
PKPeter R. Kinget
Peter R. Kinget
This work presents a low-complexity IR-UWB chipset which achieves synchronization and demodulation at the receiver relying only on a ring oscillator clock. The modulation scheme used, synchronized-OOK (S-OOK), permits low power timing acquisition and data reception with a static CMOS digital synchronizer and demodulator counting 61 logic elements. The receiver consists of a modified energy detector (ED) that allows to asynchronously receive UWB pulses in presence of narrowband interference (NBI) with power levels up to -5 and -16 dBm for 5.4 and 2.4 GHz continuous wave interfering signals respectively. The sensitivity is -60/ -66 dBm with an overall energy dissipation of 2.9/3.9 nJ/bit for a 1 Mbps S-OOK PRBS data stream and a 100% power duty cycle. The complete demodulation and synchronization digital back-end consumes only 0.2 mW (including on-chip output buffers) during normal operation. The IR-UWB transmitter is based on a gated LC oscillator and achieves pulse durations of ~2 ns for bandwidths of 500 MHz. It consumes 249 pJ/bit energy per bit at 1 Mbps OOK.

1 February 2010
Verified
Conference Paper
Closed access
MCMarco Crepaldi
Marco Crepaldi
CLChen Li
Chen Li
KDKeith Dronson
Keith Dronson
JFJorge Fernandes
Jorge Fernandes
PKPeter Kinget
Peter Kinget
A short-range 1 Mb/s 3.8 GHz IR-UWB transceiver in 90 nm CMOS uses 1.5 pulse/bit synched-OOK modulation, enabling low-complexity 200 pJ/b digital demodulation and synchronization. An interference-robust asynchronous energy detector receiver can tolerate interferers up to -5 dBm. The power-gated oscillator-based transmitter has a power efficiency of 10.4%.

13 January 2015 in Journal of Materials Science: Materials in Medicine
Verified
Journal Article
Closed access
PDF file
SFSonia Fiorilli
Sonia Fiorilli
Francesco BainoFrancesco Baino
Francesco Baino
VCValentina Cauda
Valentina Cauda
MCMarco Crepaldi
Marco Crepaldi
Chiara Vitale-BrovaroneChiara Vitale-Brovarone
Chiara Vitale-Brovarone
Barbara OnidaBarbara Onida
Barbara Onida

1 September 2017
Verified
Conference Paper
Closed access
CBChiara Bartolozzi
Chiara Bartolozzi
PRPaolo Motto Ros
Paolo Motto Ros
FDFrancesco Diotalevi
Francesco Diotalevi
NJNawid Jamali
Nawid Jamali
LNLorenzo Natale
Lorenzo Natale
DDDanilo Demarchi
Danilo Demarchi
We propose a method to compress the enormous amount of data originating from tactile sensors is presented that explicitly exploits the inherent sparseness over space and time, sending tactile “events” only when a contact is detected. The resulting modular architecture is based on FPGA modules that acquire data samples from off-the-shelf tactile sensors based on capacitive transducers and generate and transmit an event-driven readout. This architecture has been specifically implemented for integration on robots with a large number of tactile sensors, to reduce communication bandwidth, power and processing requirements. An asynchronous serial address-event representation protocol further optimises effective data transmission rate (efficiency of 94.1%) and latency (340 ns) with respect to more common transmission protocols (e.g., Ethernet, CAN). We propose two complementary algorithms for the translation of raw-data into events, optimising data rate and bandwidth, or exploiting the asynchronous nature of the event-driven encoding and the temporal information within the sensory signal. Data reduction capability can reach up to 20 % of the correspondent clock-based encoding, with limited information loss due to the compression.

20 April 2021 in IEEE Access
Verified
Journal Article
Open access
PIPietro Ibba
Pietro Ibba
MCMarco Crepaldi
Marco Crepaldi
GCGiuseppe Cantarella
Giuseppe Cantarella
GZGiorgio Zini
Giorgio Zini
ABAlessandro Barcellona
Alessandro Barcellona
PLPaolo Lugli
Paolo Lugli
This paper presents a portable impedance analyzer based on the AD5933 integrated circuit, specifically designed for fruit quality monitoring throughout its entire supply chain. The custom designed system allows to flexibly tune the parameters (i.e. excitation voltage, feedback resistor, settling time) for each AD5933 frequency range from 10Hz to 100kHz, leading to a precise system calibration and consequently, measurement. FruitMeter runs MicroPython on an STM32 microcontroller, allowing ease of development, advanced low-power mode, and both on-demand and scheduled measurements. The system employs Low-Energy Bluetooth and USB communication with a micro SD data storage which, together with its small size (7.5 ×2 ×4cm in volume) and the 300mAh rechargeable battery with USB recharge, increases the system portability and connectivity, critical for smart agriculture on-field applications. The developed portable system is validated by comparing its performance with a benchtop impedance analyzer with both passive components and fruit samples (apple, avocado, banana, mango and tomato). The comparison resulted in an average Root Mean Square Error (RMSE) of 1.0% and 4.3% for the passive components and of 1.36% and 6.8% for the fruit samples, for impedance magnitude and phase, respectively. We finally validated the system for a real use-case regarding the evaluation of banana aging evolution.

7 October 2020 in Cerebral Cortex
Verified
Journal Article
Open access
PDF file
RSR Somervail
R Somervail
FZF Zhang
F Zhang
GNG Novembre
G Novembre
RBRory Bufacchi
Rory Bufacchi
YGY Guo
Y Guo
GIG D Iannetti
G D Iannetti
Living in rapidly changing environments has shaped the mammalian brain toward high sensitivity to abrupt and intense sensory events—often signaling threats or affordances requiring swift reactions. Unsurprisingly, such events elicit a widespread electrocortical response (the vertex potential, VP), likely related to the preparation of appropriate behavioral reactions. Although the VP magnitude is largely determined by stimulus intensity, the relative contribution of the differential and absolute components of intensity remains unknown. Here, we dissociated the effects of these two components. We systematically varied the size of abrupt intensity increases embedded within continuous stimulation at different absolute intensities, while recording brain activity in humans (with scalp electroencephalography) and rats (with epidural electrocorticography). We obtained three main results. 1) VP magnitude largely depends on differential, and not absolute, stimulus intensity. This result held true, 2) for both auditory and somatosensory stimuli, indicating that sensitivity to differential intensity is supramodal, and 3) in both humans and rats, suggesting that sensitivity to abrupt intensity differentials is phylogenetically well-conserved. Altogether, the current results show that these large electrocortical responses are most sensitive to the detection of sensory changes that more likely signal the sudden appearance of novel objects or events in the environment.