Due to advances in its effectiveness and efficiency, solar thermal energy is becoming increasingly attractive as a renewal energy source. Efficient energy storage, however, is a key limiting factor on its further development and adoption. Storage is essential to smooth out energy fluctuations throughout the day and has a major influence on the cost-effectiveness of solar energy systems. This review paper will present the most recent advances in these storage systems. The manuscript aims to review and discuss the various types of storage that have been developed, specifically thermochemical storage (TCS), latent heat storage (LHS), and sensible heat storage (SHS). Among these storage types, SHS is the most developed and commercialized, whereas TCS is still in development stages. The merits and demerits of each storage types are discussed in this review. Some of the important organic and inorganic phase change materials focused in recent years have been summarized. The key contributions of this review article include summarizing the inherent benefits and weaknesses, properties, and design criteria of materials used for storing solar thermal energy, as well as discussion of recent investigations into the dynamic performance of solar energy storage systems.
The sorption behavior of biochar derived from green seaweed (Ulva reticulata) toward arsenic(V) ions was explored in both batch and continuous modes. The pH edge experiments indicated optimum arsenic(V) sorption observed at pH 4, with maximum sorptional capacity of 7.67 mg/g through isotherm experiments. The kinetic experimental trials indicated that arsenic(V) sorption onto biochar was a fast electrostatic attraction process, with maximum removal occurred within 30 min. The sorption isotherms were modeled using the Toth, Redlich–Peterson, Langmuir and Freundlich isotherm models while the adsorption kinetics was modeled using the pseudo-first- and pseudo-second-order kinetic equations. The three-parameter models (Redlich–Peterson and Toth) better described the isotherm data, whereas pseudo-first-order model represented kinetic data well with low error and high correlation coefficient values. Among the different alkaline and acidic elutants investigated, the solution of 0.01 M NaOH effectively desorbed arsenic(V) from spent biochar. The feasibility of the biochar in continuous remediation of arsenic(V) from contaminated waters was explored in an up-flow fixed column. The biochar exhibited arsenic(V) removal efficiency and sorptional uptake of 59.5% and 8.12 mg/g, respectively. The biochar-loaded column was effectively desorbed using NaOH (0.01 M), with desorption efficiency of 99.5%.
4 July 2019 in International Journal of Chemical Engineering
Nowadays water bodies across the world are heavily polluted due to uncontrollable contamination of heavy metal particles, toxic dyes, and other harmful wastes discharged by emerging industries other than normal domestic wastages. This contamination needs sufficient control to protect the natural water bodies. There are various methodologies to be followed to perform wastewater treatment, in which the adsorption method of filtration is found to be efficient. The adsorption method is a high priority and preferable filtration method compared to other waste water treatment methods due to its peculiar characteristics. Considering the adsorption method, there are multiple options available in selecting material and methodology for the filtration process. In selecting the filtering material, there is much attraction towards graphene and its oxides, which have widespread range of differential applications in commercial industries because of their eco-friendly characteristic features. The importance of various graphene composites and their chemical properties is found to be significant in various fields. Analyzing the adsorbing properties of graphene widely, this article deeply reviews about the improvements and the technologies identified for using graphene and (GO) graphene oxide in wastewater treatment taken into discussion elaborately. Therefore, in this hard review, the advantages and demerits of using graphene for wastewater treatment as well as improving its properties to make it more suitable for wastewater treatment are detailed.
The present work explored biosorption of Zn(II) ions from aqueous and zinc-bearing factory effluent using marine seaweed Ulva lactuca. The batch pH edge experiments using aqueous zinc solution indicated that Zn(II) uptake by U. lactuca was found to be maximum at pH 4.5 and the batch isotherm trials performed at pH 4.5 resulted in maximum uptake capacity of 128.0 mg Zn(II)/g. With 0.1 M CaCl2 (pH 3.5, HCl) as elutant, the elution of Zn(II) ions from Zn(II)-laden U. lactuca biosorbent was effective with possible regeneration and reuse for three cycles. The zinc industrial effluent was found to comprise of 87.8 mg/L of zinc ions along with excess co-ions and high total dissolved solids (838.1 mg/L). Owing to this, Zn(II) uptake from electroplating effluent by U. lactuca was suppressed due to competition from other ions. Continuous-flow sorption trials were conducted at flow rate of 5 mL/min in an up-flow fixed column. The existence of surplus competing ions in zinc wastewater influenced the Zn(II) biosorption by U. lactuca. U. lactuca-loaded packed column exhibited uptakes of 78.3 and 70.8 mg Zn(II)/g for aqueous solution and effluent, respectively. The results of three continuous sorption–desorption cycles demonstrated that reuse of U. lactuca biosorbent in remediation of zinc-containing wastewaters was practical and economical.
3 December 2018 in Separation Science and Technology
In the present investigation, date seed-derived biochar was applied as economic and effective sorbent for remediation of reactive dye from contaminated solutions. Biochar produced at 350°C through pyrolysis process exhibited reactive black 5 (REB5) sorption capacity 2.7 times higher than virgin date seeds. The surface of biochar was analyzed through Fourier transform infrared and scanning electron microscope data. The maximum REB5 uptake determined through the Langmuir model was found to be 113.4 mg/g. The REB5 sorption kinetics were accurately described by the pseudo-first-order model than pseudo-second-order model. Thermodynamic parameters indicated that REB5 sorption was spontaneous, feasible, and endothermic process.