The 1999 NATO bombing of the oil refinery in Novi Sad (Yugoslavia) has heavily contaminated the Danube River and its sediments, as well as the surrounding soil and groundwater. The destruction of the factories released 73,569 tons of crude oil of which 90% was incinerated, 560 tons reached the Danube River, and the remainder was spilled onto the soil. The contents of oil and oil derivatives in the soil were in the range of 3 to 42,000 mg/kg. The first soil layer contained an average of 67,000 mg/kg of crude oil and oil derivatives. The layers beneath it, above the groundwater table, contained 56 ml/l of free oil derivatives in the drained water. The spreading of this pollution could imperil the groundwater quality in the water supply zone because the refinery is located in the hinterland of the zone. The quality of water and sediment samples was monitored from April 1999 to November 2000 by measuring concentrations of hydrocarbons and polyaromatic hydrocarbons (PAH). The hydrocarbon content in the Danube River water in October 2000 was about 20% of the value measured at the time of the accident. Immediately after the accident the concentration of mineral oil in the surface sediment was in the range of 0.11 to 0.29 g/kg. At the same time PAH concentrations in the river sediment were up to 160 mg/kg, depending on the sampling site location. The values showed a decrease in the course of further monitoring.
1 February 2013 in Soil and Sediment Contamination: An International Journal
In this work, the simultaneous application of bipolar electrodes and a longer cathodic compartment length without agents addition was used as an enhanced electrokinetic treatment of Ni-, Cd-, and Pb-contaminated sediment. Conventional and enhanced treatments were investigated and their efficacy assessed by comparing the residual metals content in the sediment with values given by Dutch standards. After conventional treatment removals of 20%, 19%, and 31% for Ni, Cd, and Pb were achieved, whereas the enhanced treatment achieved removal efficacies of 36% for Ni, 42% for Cd, and 43% for Pb. Results indicate that the simultaneous application of the techniques mentioned is effective for removing Ni and Pb whereas Cd was not removed to the desired level. Here we show that the addition of chemicals is not necessary to increase the efficacies of electrokinetic sediment treatments, so the simultaneous application of the techniques mentioned can be described as environmentally friendly.
1 January 2014 in Journal of the Serbian Chemical Society
In this study, the sorption behaviour of 1,3-benzothiazole (BT) and 2-(methylthio)benzothiazole (MTBT) was investigated on Danube geosorbent under equilibrium and nonequilibrium conditions. All sorption isotherms fitted well with the Freundlich model (R2=0.932-0.993). The results showed that organic matter of the Danube geosorbent has a higher sorption affinity for the more hydrophobic MTBT compared to BT. However, sorption-desorption experiments showed that MTBT was more easily desorbed than BT molecules, which indicates the importance of absorption relative to adsorption in the overall sorption mechanism of MTBT. In general, molecules of BT and MTBT were more easily desorbed in the lower concentration range, which resulted in an increase in the hysteresis indices with increasing concentrations. Column experiments revealed that retention of the investigated compounds on the aquifer material followed the compound?s hydrophobicity. BT showed a lower retention, in accordance with its lower sorption affinity obtained in the static experiments, while MTBT showed a greater sorption affinity, and thus had a longer retention time on the column. Thus during transport BT represent greater risk for groundwaters than MTBT. These results have increased our understanding of benzothiazoles sorption and desorption process which represent one of the most important factors which influence the behaviour of organic compounds in the environment.
In the central Banat region (Northern Serbia), groundwater is used as a drinking water source. Raw water originates from a 40–80 m and 100–150 m deep layer. It contains a high amount of natural organic matter (DOC = 9.17 ± 0.87 mg C/L) with a trihalomethanes formation potential of 448 ± 88.2 μg/L and a haloacetic acid formation potential of 174 ± 68.9 μg/L. A high amount of arsenic (86.0 ± 3.4 μg/L) is also found in this water. This study used a pilot-scale system to investigate the possibilities of combining polyaluminium chloride and ferrous-chloride to remove disinfection by-products precursors and arsenic by coagulation. Two treatment trains with different pre-treatment steps were investigated (ozone vs. H2O2/O3). For the final water polishing, filtration with granulated activated carbon (GAC) was applied. Both investigated treatment lines achieved a satisfactory chemical water quality. Simulation of disinfection conditions was performed and the contents of trihalomethanes and haloacetic acids measured, to investigate whether the chemical quality of the water remained satisfactory over a 48 hour period.
1 January 2012 in Journal of the Serbian Chemical Society
Landfarming bioremediation was performed over 2 years on soil heavily polluted with weathered oil and oil derivatives: 23200 mg kg-1 of mineral oil, 35300 mg kg-1 total hydrocarbons, and 8.65 mg kg-1 of total PAHs. During the experiment, mineral oil, total hydrocarbon and PAH concentrations decreased by approximately 53%, 27% and 72%, respectively. A GC/MS-Scan was used to identify the crude oil components that persist after bioremediation treatment of contaminated soil and the metabolites generated during this process. The data shows that in weathered-hydrocarbons contaminated soil, the number of initially detected compounds after the bioremediation process further decreased over a 2 year period, and at the same time several new compounds were observed at the end of experiment. Higher persistence was also shown for heavier n-alkanes and branched alkanes, which could be detected over a longer period of time. The analysis highlights the importance of n-alkanes, their substituted derivatives and polycyclic aromatic hydrocarbons as the most significant pollutants