1 October 2006 in NDT & E International
1 December 2005 in NDT & E International
7 May 2003 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Guided acoustic and ultrasonic waves have been utilized in various manners for non-destructive evaluation and testing. If a guided wave mode is dispersive, a pulse of energy will spread out in space and time as it propagates. For a long-range guided wave inspection application, this constrains the choice of operating point to regions on the dispersion curves where dispersion effects are small. A signal processing technique is presented that enables this constraint on operating point to be relaxed. The technique makes use of a priori knowledge of the dispersion characteristics of a guided wave mode to map signals from the time to distance domains. In the mapping process, dispersed signals are compressed to their original shape. The theoretical basis of the technique is described and an efficient numerical implementation is presented. The robustness of the technique to inaccuracies in the dispersion data is also addressed. The application of the technique to experimental data is shown and the resulting improvement in spatial resolution is demonstrated. The implications of using dispersion compensation in practical systems are briefly discussed.
1 April 2010 in Ultrasonics
1 March 2010 in NDT & E International
28 August 2007 in Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences
Structural health monitoring (SHM) using guided waves is one of the only ways in which damage anywhere in a structure can be detected using a sparse array of permanently attached sensors. To distinguish damage from structural features, some form of comparison with damage-free reference data is essential, and here subtraction is considered. The detectability of damage is determined by the amplitude of residual signals from structural features remaining after the subtraction of reference data. These are non-zero due to changing environmental conditions such as temperature. In this paper, the amplitude of the residual signals is quantified for different guided-wave SHM strategies. Comparisons are made between two methods of reference signal subtraction and between two candidate sensor configurations. These studies allow estimates to be made of the number of sensors required per unit area to reliably detect a prescribed type of damage. It is shown that the number required is prohibitively high, even in the presence of modest temperature fluctuations, hence some form of temperature compensation is absolutely essential for guided-wave SHM systems to be viable. A potential solution is examined and shown to provide an improvement in signal suppression of approximately 30 dB, which corresponds to two orders of magnitude reduction in the number of sensors required.