31 October 2006 in Proceedings of the National Academy of Sciences
Product state distributions of the CO produced in the 308-nm photolysis of acetaldehyde show clear evidence of two dissociation mechanisms. One is attributed to the conventional transition state mechanism predicted by theory, with high rotational and translational energy of the CO and a pronounced v⊥J vector correlation. However, as much as 15% of the reaction flux proceeds via another pathway that produces low CO rotational and translational energy, very high CH 4 internal energy, and no correlation between the CO velocity and angular momentum vectors. The attributes of this channel are dynamically similar to the recently reported “roaming atom” mechanism in formaldehyde. We therefore speculate that the second pathway in acetaldehyde also occurs via a roaming mechanism in the CH 3 + HCO exit channel that decays into the CH 4 + CO channel.
2 September 2008 in Proceedings of the National Academy of Sciences
Reaction pathways that bypass the conventional saddle-point transition state (TS) are of considerable interest and importance. An example of such a pathway, termed “roaming,” has been described in the photodissociation of H 2 CO. In a combined experimental and theoretical study, we show that roaming pathways are important in the 308-nm photodissociation of CH 3 CHO to CH 4 + CO. The CH 4 product is found to have extreme vibrational excitation, with the vibrational distribution peaked at ≈95% of the total available energy. Quasiclassical trajectory calculations on full-dimensional potential energy surfaces reproduce these results and are used to infer that the major route to CH 4 + CO products is via a roaming pathway where a CH 3 fragment abstracts an H from HCO. The conventional saddle-point TS pathway to CH 4 + CO formation plays only a minor role. H-atom roaming is also observed, but this is also a minor pathway. The dominance of the CH 3 roaming mechanism is attributed to the fact that the CH 3 + HCO radical asymptote and the TS saddle-point barrier to CH 4 + CO are nearly isoenergetic. Roaming dynamics are therefore not restricted to small molecules such as H 2 CO, nor are they limited to H atoms being the roaming fragment. The observed dominance of the roaming mechanism over the conventional TS mechanism presents a significant challenge to current reaction rate theory.
28 January 2006 in Journal of the American Chemical Society
1 January 1996 in Macromolecules
15 December 1989 in The Journal of Chemical Physics
The photofragment internal and translational energy distributions resulting from the 193 nm photolysis of acetone have been measured. Vacuum-ultraviolet laser-induced fluorescence was used to probe the CO fragment, and multiphoton ionization time-of-flight mass spectrometry was used to probe the CH3. A Boltzmann distribution was observed to fit each degree of freedom with the following characteristic temperatures: CO: Tvib =2700 K, Trot =3000 K, Ttrans =3000 K; CH3: Tvib =800 K, Trot =500 K, Ttrans =3500 K. No evidence was found for two distinct CH3 populations, as might be characteristic of a stepwise reaction. Energy partitioning between the fragments was fit well by a simple impulsive model in which the available energy is divided equally between the two dissociating C–C bonds, the two bonds cleaving in rapid succession on a time scale short enough to allow little redistribution of energy into the methyl degrees of freedom.
26 May 2015 in Polymer Chemistry
Curcumin exhibits broad ground state light absorption and can act as a photoinitiator for the free radical photopolymerization of methacrylates under air upon exposure to different household LED bulbs. The effects of temperature and various additives on the photoinitiation efficiency of curcumin-based systems have been investigated. The curcumin-based system exhibits the highest photoinitiation efficiency at 25 °C. Additives also play an important role in the photoinitiation efficiency, and well-designed systems can even demonstrate higher efficiency than the commercial type I photoinitiator [phenylbis(2,4,6-trimethylbenzoyl)phosphine oxide (XBPO)] and type II photoinitiator [camphorquinone (CQ)]. Interestingly, the curcumin/diphenyliodonium hexafluorophosphate/triphenylphosphine combination is a capable multicolor photoinitiating system able to initiate free radical photopolymerization under air upon exposure to UV, blue, green, yellow, red, and warm white household LED bulbs. In addition, reversible addition–fragmentation chain transfer (RAFT) photopolymerization of N-isopropylacrylamide can also be achieved using a curcumin-based system under the irradiation of a blue LED bulb. The photochemical mechanisms associated with the generation of radicals from the investigated photoinitiating systems are investigated by different techniques (fluorescence, steady state photolysis, and electron spin resonance spin-trapping methods) and discussed in detail. More interestingly, the polymer sample produced through the photopolymerization process using the curcumin-based photoinitiating system demonstrates almost no toxicity to human fibroblast Hs-27 cells, endowing this photoinitiating system with great potential for the fabrication of biocompatible polymeric materials.