22 May 1998 in The Journal of Chemical Physics
We present a method for expressing a potential energy surface (PES) for polyatomic molecules as an interpolation of local Taylor expansions in internal coordinates. This approach extends and replaces an earlier method which was only directly applicable to molecules of no more than four atoms. In general, the local Taylor expansions are derived from ab initio quantum calculations. Here, the methodology is evaluated by comparison with an analytic surface for the reactions Approximately 1000–1300 data points are required for an accurate 12-dimensional surface which describes both forward and backward reactions, at the energy studied.
8 April 1995 in The Journal of Chemical Physics
A recently proposed scheme for interpolating and iteratively improving molecular potential energy surfaces [Ischtwan and Collins, J. Chem. Phys. 100, 8080 (1994)] is evaluated by comparison with an analytic surface for the OH+H2→H2O+H reaction. An improvement in the procedure for constructing the potential surface is suggested and implemented. The most efficient means of converging the surface is determined. It is found that the probability of reaction, for example, may be accurately calculated using of the order of 200–400 data points to define the potential energy surface.
2 September 2008 in Proceedings of the National Academy of Sciences
Reaction pathways that bypass the conventional saddle-point transition state (TS) are of considerable interest and importance. An example of such a pathway, termed “roaming,” has been described in the photodissociation of H 2 CO. In a combined experimental and theoretical study, we show that roaming pathways are important in the 308-nm photodissociation of CH 3 CHO to CH 4 + CO. The CH 4 product is found to have extreme vibrational excitation, with the vibrational distribution peaked at ≈95% of the total available energy. Quasiclassical trajectory calculations on full-dimensional potential energy surfaces reproduce these results and are used to infer that the major route to CH 4 + CO products is via a roaming pathway where a CH 3 fragment abstracts an H from HCO. The conventional saddle-point TS pathway to CH 4 + CO formation plays only a minor role. H-atom roaming is also observed, but this is also a minor pathway. The dominance of the CH 3 roaming mechanism is attributed to the fact that the CH 3 + HCO radical asymptote and the TS saddle-point barrier to CH 4 + CO are nearly isoenergetic. Roaming dynamics are therefore not restricted to small molecules such as H 2 CO, nor are they limited to H atoms being the roaming fragment. The observed dominance of the roaming mechanism over the conventional TS mechanism presents a significant challenge to current reaction rate theory.
8 April 1995 in The Journal of Chemical Physics
Trajectory data are reported for the reaction CH4+H→CH3+H2, designed to provide information that can be used to test approximate quantitative theories for the dynamics of abstraction reactions. A potential function was devised which properly reflects the nuclear permutation symmetry of the process. Microscopic reaction rate coefficients were obtained as functions of fixed rotational and vibrational energy, and of the angular momentum. The data indicated significant uncoupling between the various modes although, at a minimum, the symmetric stretch is directly coupled to the reaction coordinate at the transition state. The data were used to test the assumption that the total angular momentum, J, may be approximated by the orbital angular momentum, L. L is approximately conserved from the reactant to the saddle point configuration in reactive and nonreactive collisions and may be well approximated by J. The angular momentum about the long axis of the reacting system (equivalent to the K quantum number) is not conserved in either reactive or nonreactive trajectories.
7 September 2012 in Science
Enols in the Atmosphere?: Keto/enol tautomerization (HC−C=O→C=C−OH) plays a central role in the chemistry of carbonyl compounds in a solution in which solvent and catalytic acids or bases can facilitate the proton transfer from C to O and back again. In contrast, analyses of atmospheric chemistry tend to exclude enol structure, on the assumption that tautomerization does not proceed regularly in gas phase.
Andrews
et al.
(p. 1203 , published online 16 August) used isotopic labeling to probe the photoisomerization pathway of gaseous acetaldehyde in the lab and discovered evidence for an enol. Subsequent modeling indicates that photogenerated enols could build up sufficiently in the troposphere to account for previously puzzling observations of organic acids in the atmosphere.
8 December 1995 in The Journal of Chemical Physics
In this paper we evaluate the use of higher order derivatives in the construction of an interpolated potential energy surface for the OH+H2→H2O+H reaction. The surface construction involves interpolating between local Taylor expansions about a set of known data points. We examine the use of first, second, third, and fourth order Taylor expansions in the interpolation scheme. The convergence of the various interpolated surfaces is evaluated in terms of the probability of reaction. We conclude that first order Taylor expansions (and by implication zeroth order expansions) are not suitable for constructing potential energy surfaces for reactive systems. We also conclude that it is inefficient to use fourth order derivatives. The factors differentiating between second and third order Taylor expansions are less clear. Although third order surfaces require substantially fewer data points to converge than second order surfaces, this faster convergence does not offset the large cost incurred in calculating numerical third derivatives. We therefore conclude that, without an efficient means for calculating analytic third derivatives, second order derivatives provide the most cost‐effective means of constructing a global potential energy surface by interpolation.