Yigit Alper Atalay

Yigit Alper Atalay

Auto-generated profile, based on publicly available information

Yigit Alper Atalay

ÖZYEĞİN ÜNİVERSİTESİ, MÜHENDİSLİK FAKÜLTESİ

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2024 in Turkish Journal of Civil Engineering
Verified
Journal Article
Open access
PDF file
YAYigit Alper Atalay
Yigit Alper Atalay
TATolga Aydın
Tolga Aydın
ZBZeynep. B. Bundur
Zeynep. B. Bundur
PMPozhhan Mokhtari
Pozhhan Mokhtari
MGMehmet Ali Gülgün
Mehmet Ali Gülgün
Zoubeir LAFHAJZoubeir LAFHAJ
Zoubeir LAFHAJ
Geopolymer binders have been highlighted due to their low carbon emission during production and processing. While metakaolin and F-type fly ash are commonly used as raw materials for aluminosilicate-based geopolymers, the long heat-curing requirements for hardening and strength development still pose challenges. This paper investigates the possible use of a hybrid microwave curing technique to design a set-on-demand approach to reduce the duration of heat curing in metakaolin-based geopolymer. The experimental design was established for samples with three different molar ratios (MR; 1.3,1.5, and 1.7) containing metakaolin, fly ash, and silica fume. Samples were subjected to 3 different curing regimes: oven curing, microwave (MW) curing, and hybrid curing (a combination of optimized microwave and oven curing). The performance evaluation was based on compressive strength, dimensional stability, and alkali leaching (efflorescence). Implementing only MW curing resulted in a significant decrease in compressive strength compared to their counterpart oven-cured samples. The reduction of compressive strength was more pronounced at lower molar ratios. The design of a hybrid curing approach where a portion of oven curing was replaced by MW resulted in a higher strength development than those only cured with MW. Similarly, the efficiency of hybrid curing was more pronounced in samples having MR of 1.5 and 1.7. Using MW curing in the geopolymer binders did not affect the alkali leaching; however, it increased the material’s drying shrinkage. Results showed that replacing a portion of oven curing with microwave curing in a hybrid approach can increase the operation speed and the hardening rate without significantly decreasing compressive strength.