Experimental investigations were conducted to assess the impact of factors such as relative humidity (RH%) and the H 2 O molarity of waterglass on the efflorescence behavior of geopolymer composites. Samples with sodium (Na) and potassium (K) bases were prepared, having varying waterglass molarities (M) (at 11 and 13 moles of water). These samples were categorized into three groups exposed to different average RH ranges: (i) 0%–70% RH, (ii) 70%–90% RH, and (iii) 90%–100% RH. This study analyzed the occurrence of efflorescence and its stability, employing analytical techniques such as x‐ray diffraction, scanning electron microscopy, and energy‐dispersive spectroscopy to examine the formation and characteristics of efflorescent deposits. Additionally, mechanical testing was conducted to evaluate the compressive and flexural strengths of the geopolymer samples, considering the impact of efflorescence on their durability. For instance, in the composite geopolymer specimen containing 11 M water, at a RH of 80%, the compressive strength is decreased by approximately 25% from 56.4 to 42.3 MPa. The findings revealed that when the RH falls within the 70%–90% range, a decrease in water molar content from 13 M to 11 M leads to a more pronounced occurrence of efflorescence when compared to other conditions. Efflorescence may also occur in different RH ranges and water molarities, but its occurrence is significantly lower compared to the 70%–90% RH and 11 M water.
Geopolymer binders have been highlighted due to their low carbon emission during production and processing. While metakaolin and F-type fly ash are commonly used as raw materials for aluminosilicate-based geopolymers, the long heat-curing requirements for hardening and strength development still pose challenges. This paper investigates the possible use of a hybrid microwave curing technique to design a set-on-demand approach to reduce the duration of heat curing in metakaolin-based geopolymer. The experimental design was established for samples with three different molar ratios (MR; 1.3,1.5, and 1.7) containing metakaolin, fly ash, and silica fume. Samples were subjected to 3 different curing regimes: oven curing, microwave (MW) curing, and hybrid curing (a combination of optimized microwave and oven curing). The performance evaluation was based on compressive strength, dimensional stability, and alkali leaching (efflorescence). Implementing only MW curing resulted in a significant decrease in compressive strength compared to their counterpart oven-cured samples. The reduction of compressive strength was more pronounced at lower molar ratios. The design of a hybrid curing approach where a portion of oven curing was replaced by MW resulted in a higher strength development than those only cured with MW. Similarly, the efficiency of hybrid curing was more pronounced in samples having MR of 1.5 and 1.7. Using MW curing in the geopolymer binders did not affect the alkali leaching; however, it increased the material’s drying shrinkage. Results showed that replacing a portion of oven curing with microwave curing in a hybrid approach can increase the operation speed and the hardening rate without significantly decreasing compressive strength.