13 September 2007 in Chemical Reviews
1 March 2018 in Energy & Environmental Science
High performance of SnP2O7-based intermediate temperature fuel cells was obtained with a quaternary ammonium-biphosphate ion-pair coordinated polymer electrolyte.
15 July 2014 in Journal of the Electrochemical Society
CeOx is an excellent free radical scavenger to improve polymer electrolyte membrane durability. However, this metal oxide will dissolve during accelerated stress testing (AST), with the resulting cations transporting to the cathode catalyst layer (CCL) leading to performance reduction/degradation of the PEMFC. Controlling the rate of CeOx dissolution is therefore of great importance, as it may be possible to maintain sufficient Ce cations for free radical scavenging while minimizing the impact of these cations on the CCL. Here the effect of CeOx crystallite size on CeOx dissolution was investigated. Three CeOx additives were prepared having crystallite sizes of 6, 13, or 25 nm. An ex-situ method was used to evaluate the chemical stability of these three CeOx samples, as well as one commercially available CeOx. It was determined that surface area, rather than crystallite size, is the best predictor of chemical stability. In-situ membrane electrode assembly AST cycling was then performed, demonstrating that when low loadings of CeOx (0.006 mg/cm2) are used, the ex-situ method correctly predicts trends in end of life (EOL) performance. Finally, it is shown that increasing the anode RH during AST cycling leads to significantly higher EOL performance losses.
1 May 2015 in Journal of Power Sources
28 September 2007 in ECS Transactions
Platinum surface area was chemically and electrochemically characterized using X-ray diffraction (XRD), H2S adsorption, and electrochemical techniques including half-cells and fuel cells. Electrode ink processing and composition were found to have a strong impact on observed surface area with increased processing leading to a reduction in platinum surface area. Fuel cell electrode measurements show a significant portion of the platinum may not be available. This unutilized Pt may be due to either ionic or electronic connectivity as evidence exists to support both ionic and electronic isolation.
1 January 2013 in ECS Electrochemistry Letters
In-doped tin pyrophosphate materials were synthesized with varying metal to phosphate ratios to assess the influence of an excess amorphous polyphosphate phase on conductivity. Total conductivity at 250°C increased with phosphorus to metal (P:M) ratio, with the 2.81 P:M ratio material exhibiting maximum conductivity of 10−2 and 10−1 Scm−1 in dry and humidified N2. XRD measurements revealed no systematic change in lattice parameter with increasing P:M. These results combined with supporting spectroscopy, suggest that a grain-boundary polyphosphate phase is required to achieve high conductivity in the low-intermediate temperature range. The materials were relatively stable and provided steady conductivities at 250°C.