Nils Eingrüber

Nils Eingrüber

Auto-generated profile, based on publicly available information

Nils Eingrüber

University of Cologne, Cologne, Germany

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

10 July 2023 in Advances in Science and Research
Verified
Journal Article
Open access
PDF file
NENils Eingrüber
Nils Eingrüber
WKWolfgang Korres
Wolfgang Korres
ULUlrich Löhnert
Ulrich Löhnert
KSKarl Schneider
Karl Schneider
As the frequency of extreme heat events in cities is significantly increasing due to climate change, the implementation of adaptation measures is important for urban planning. Microclimate modelling approaches enable scenario analyses and evaluations of adaptation potentials. An ENVI-met microclimate model was setup for a heterogeneous urban study area in Cologne/Germany characterized by closed building structures in the eastern part and an urban park area in the western part. The goal of this paper is to evaluate the model sensitivity and performance to different wind direction forcing and demonstrate the importance of accurate wind forcing data for precise microclimate modelling evaluated with sensor measurements. To this end, we compared simulated air temperatures at 3 m height level using measured wind direction forcing data with simulated air temperatures using constant wind direction forcing from west, north, east and south direction. All other forcing data like wind speed were kept exactly the same as in the reference run. This sensitivity study was performed for a warm summer day in 2022. The model results of all five model runs (reference plus four scenarios) were compared to microclimatological measurements derived from one station of a dense meteorological sensor network located in the study area using the simulated mean air temperatures. We found significant temperature differences between the four sensitivity tests and the reference run as well as to the sensor measurements. Temperature differences between the reference run and the measurements were small and a high statistical model fit could be determined (Nash Sutcliffe Model Efficiency Coefficient/NSE = 0.91). The four model runs with constant wind directions showed significantly larger differences to measurement data and a worse statistical correlation between simulated and observed data (NSE between 0.62 and 0.15). For constant west winds, cooler air temperatures and higher wind speeds were found in the urban park and in the streets and courtyards east of the park. Constant east wind causes warmer air temperatures in the urban park area and lower wind speeds in the street canyons and inner courtyards. This shows that cooling effects in adjacent building blocks due to the greened urban park largely depend on the wind direction. The sensitivity tests show that the wind direction effect can result in local air temperature differences of up to 4 K on average. These results shows that even on summer days with low wind speeds, accurate wind direction data is highly relevant for accurate air temperature simulation. This finding can have important implications for urban planning and the design of green infrastructures in cities, e. g. for the design of fresh air corridors.

18 August 2022 in Advances in Science and Research
Verified
Journal Article
Open access
PDF file
NENils Eingrüber
Nils Eingrüber
WKWolfgang Korres
Wolfgang Korres
KSKarl Schneider
Karl Schneider
Cities are particularly affected by climate change impacts. Due to global warming, the frequency and intensity of summer heat events increases for many cities around the globe. Urban climatological studies have shown significant positive trends in the number of hot days and tropical nights. Heat stress is an important health as well as economic risk. Thus, urban planning needs to adapt to climate change. This requires a sound scientific analysis of different adaptation measures and management options, which must be based on appropriate data, models and scenarios to assess their suitability and efficacy. The goal of this paper is to assess the suitability of a low cost weather station network consisting of 33 NETATMO weather sensors and ultrasonic anemometers to measure air temperature, relative air humidity, wind speed and wind direction of a 16 ha study area in Cologne with high temporal and spatial resolution to support microclimatological modelling. The temperature and humidity sensors were calibrated against a research grade reference sensor under laboratory conditions. In addition, a research grade meteorological station (Campbell Sci.) was set up in the study area as a reference. The NETATMO sensors were placed to identify local microclimatic effects due to different surface types, vegetation and building structures. Using descriptive statistical analyses and pairwise comparisons, significant differences in the microclimatic conditions of the various sites were found, which can clearly be attributed to specific small scale microclimate factors. Significant differences were particularly identified comparing an avenue and a narrow street as well as a backyard and an urban park area. The sensors proved to provide data reliably and with suitable quality to measure microclimatic effects. The choice of sensors lends itself well for citizen participation, needed to facilitate climate change adaptation. In our further research, the data will be used as reference data for microclimatological modelling with ENVI-met investigating particularly options of mitigating climate change effects.

14 January 2025 in Geoscientific Model Development
Verified
Journal Article
Open access
PDF file
NENils Eingrüber
Nils Eingrüber
ADAlina Domm
Alina Domm
WKWolfgang Korres
Wolfgang Korres
KSKarl Schneider
Karl Schneider
Many urban areas are characterized by both a growing population and an intensification of summer heat events in the context of climate change. Thus, more and more people are exposed to heat stress and corresponding health consequences. Measures for climate change adaptation, such as unsealing strategies, are needed in the existing urban fabric to reduce sensible heat flux by increasing latent heat flux to cool down the urban environment without requiring additional space or changing the basic function of the area. Unsealing measures like grass grid pavers (GGPs) can also help to reduce flooding risks due to increased infiltration and water storage capacities. Up to now, a parameterization of GGPs for microclimatic simulations is not available. To fill this research gap, we present a new GGP model parameterization developed for the fluid dynamics microclimate ENVI-met model based on field measurements with double-ring infiltrometers, etc., which can also be implemented in other microscale models in the field of urban climatology. To analyse the microclimatic effects and the cooling potential of this GGP parameterization, scenario analyses were performed using a validated ENVI-met model setup for an urban high-density study area in Cologne, Germany. An extreme scenario was designed to address the maximum cooling potential of the GGPs in comparison to the dominant sealed asphalt surfaces in the study area, along with a more realistic scenario with a usage-compatible installation of GGPs in the model domain only in side streets and inner courtyards while main streets remain sealed. We found a maximum cooling potential of up to −20.1 K for ground surface temperature and up to −7.1 K for air temperature at 1 m above ground level for the hottest hour of a simulated 3 d heat wave in summer 2022, which represents a 20-year heat event in Cologne. On spatial average, a decrease of up to −11.1 K for surface temperature and up to −2.9 K for air temperature was determined. On temporal average for the 3 d heat event, statistically significant mean temperature differences of −5.8 K for surface temperature and −1.1 K for air temperature were simulated. Cooling effects are more pronounced during the daytime for surface temperature, especially in unshaded areas, while cooling effects for air temperature are strongest during the nighttime. Model results also show that the entire air volume in the study area is cooled down due to this adaptation measure, even in areas of the domain where no surfaces have been unsealed in the scenario design. The more realistic GGP scenario shows cooling effects of a comparable magnitude to the extreme GGP scenario. Thus, even partial GGP unsealing is an effective adaptation measure for reducing extreme temperatures in cities if water availability is not limited.

20 January 2025 in Journal of Sensors and Sensor Systems
Verified
Journal Article
Open access
PDF file
NENils Eingrüber
Nils Eingrüber
WKWolfgang Korres
Wolfgang Korres
ULUlrich Löhnert
Ulrich Löhnert
KSKarl Schneider
Karl Schneider
Urban areas are particularly affected by climate change. Excessive heat waves, droughts and extreme precipitation events are the most detrimental meteorological events affecting cities and their population worldwide. Adaptation and mitigation measures must be specific for the given climatic, socio-economic and cultural conditions. To better understand differences in the natural and social environment and their effects upon climate adaptation strategies in humid and monsoon-driven climates, a densely distributed meteorological sensor network was established in an urban high-density neighbourhood in Pune, India, in 2023 for continuous long-term data collection (12 stations, 59 sensors) following the prototype network installed in the city of Cologne, Germany, in 2021 (14 stations, 58 sensors). Climate change mitigation and adaptation requires activation and participation of citizens. In order to connect the needs of research with citizen participation, it is essential (i) to provide quality-controlled microclimatic measurements with high spatial and temporal resolution; (ii) to provide a basis to analyse cause-and-effect relationships in a given urban microclimatic setting; (iii) to enable suitable climate change adaptation measures to be identified and the participation potential of stakeholders to be assessed; and (iv) to support the building of a community of learners, participants and activists towards becoming actively involved in climate change adaptation in their own living environment. The transferability and expandability of the approach requires that the measurement network must be affordable to facilitate citizen participation. Scientists can use the measurement data for example to validate physically based microclimate models like ENVI-met to simulate adaptation effects. The measurement locations of the standardized, low cost and expandable measurement network in Pune cover the full range of surface characteristics from vegetated parks to street canyons and from built-up inner courtyards to open areas, representing the heterogeneity of the microclimatic conditions within that study area. The similarity of the sensor network in both cities allows for comparison of the functionality of the system under different environmental conditions and assessment of stakeholder and citizen activation and participation in two different countries. Despite challenges arising from discontinuous power supply and radio signal interruptions due to sensor wetness during the rainy season in Pune, the data quality shows that the measurement setup is also suitable for tropical monsoon climates. Stakeholder participation was assessed by statistical analyses of the usage statistics of the NETATMO app by the citizen scientists. Significant differences in the number of app activities between Pune and Cologne were found. Despite differences in the form and intensity of active participation, citizens in both cities show great interest in getting involved in climate research and pathways for climate change adaptation, indicating the high potential of activating citizens in the transformative process towards climate-sensitive urban development.

28 June 2022
Verified
Conference Paper
Open access
NENils Eingrüber
Nils Eingrüber
KSKarl Schneider
Karl Schneider
WKWolfgang Korres
Wolfgang Korres
ULUlrich Löhnert
Ulrich Löhnert
Increasing heat exposure and heat stress due to global warming is a major problem in cities, and adaptation strategies to improve the urban microclimate are urgently needed. Successful climate change adaptation requires data, models and scenario analyses to evaluate the potentials and thermal effects of measures like green infrastructures, facade and roof greenings, shadings or light surfaces. In order to be able to estimate the effectiveness of different adaptation strategies in agglomeration areas, a physically-based 3D ENVI-met model was setup to simulate the urban microclimate of a 16 ha study area in Cologne Südstadt which is characterized by dense development in the east as well as an urban park area in the western part. In order to assess and test the model outputs, various sensitivity analyses were implemented, especially with regard to the effects of different meteorological forcing data. We compared the output data i) when using measured radiation (incoming direct and diffuse shortwave radiation and incoming longwave irradiance), and ii) when using measurements of the relative cloud cover of low-level, medium-level and high-level clouds as radiative forcing of the model. Radiation is measured with a diffusometer consisting of two pyranometers with and without a shadow ring and a pyrgeometer. The instruments are installed at our meteorological station (Campbell Scientific) in the urban park. The relative cloud cover for the different cloud levels is derived from the measurements of a close-by ceilometer. In addition to the sensitivity analyses, a model validation is carried out based on reference data of a densely distributed weather station network consisting of 33 NETATMO weather sensors and ultrasonic anemometers in the study area, which have previously been checked for long-term stability and consistency in the field and under laboratory conditions. On the basis of air temperature, relative humidity, wind speed and wind direction measurements, the quality of the ENVI-met model outputs is evaluated for statistical goodness of fit, and it is checked how accurate the ENVI-met model can represent and reproduce the actual measurements at the heterogeneous NETATMO test sites. The model validations and sensitivity analyses are accomplished for various typical weather conditions in order to show how the model quality differs between low-exchange high-pressure conditions and mixed weather conditions with different dominant wind directions. Further research will use this validated ENVI-met model to simulate and analyse the effects and potentials of various hypothetical adaptation measures taking into account climate change projections until 2099, and different scenarios will be compared in order to mitigate future heat stress and improve the urban microclimate.