Wolfgang Korres

Wolfgang Korres

Auto-generated profile, based on publicly available information

Wolfgang Korres

University of Cologne, Institute of Geography, Hydrogeography and climatology research group, 50923, Cologne, Germany

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 July 2023 in Advances in Science and Research
Verified
Journal Article
Open access
PDF file
NENils Eingrüber
Nils Eingrüber
WKWolfgang Korres
Wolfgang Korres
ULUlrich Löhnert
Ulrich Löhnert
KSKarl Schneider
Karl Schneider
As the frequency of extreme heat events in cities is significantly increasing due to climate change, the implementation of adaptation measures is important for urban planning. Microclimate modelling approaches enable scenario analyses and evaluations of adaptation potentials. An ENVI-met microclimate model was setup for a heterogeneous urban study area in Cologne/Germany characterized by closed building structures in the eastern part and an urban park area in the western part. The goal of this paper is to evaluate the model sensitivity and performance to different wind direction forcing and demonstrate the importance of accurate wind forcing data for precise microclimate modelling evaluated with sensor measurements. To this end, we compared simulated air temperatures at 3 m height level using measured wind direction forcing data with simulated air temperatures using constant wind direction forcing from west, north, east and south direction. All other forcing data like wind speed were kept exactly the same as in the reference run. This sensitivity study was performed for a warm summer day in 2022. The model results of all five model runs (reference plus four scenarios) were compared to microclimatological measurements derived from one station of a dense meteorological sensor network located in the study area using the simulated mean air temperatures. We found significant temperature differences between the four sensitivity tests and the reference run as well as to the sensor measurements. Temperature differences between the reference run and the measurements were small and a high statistical model fit could be determined (Nash Sutcliffe Model Efficiency Coefficient/NSE = 0.91). The four model runs with constant wind directions showed significantly larger differences to measurement data and a worse statistical correlation between simulated and observed data (NSE between 0.62 and 0.15). For constant west winds, cooler air temperatures and higher wind speeds were found in the urban park and in the streets and courtyards east of the park. Constant east wind causes warmer air temperatures in the urban park area and lower wind speeds in the street canyons and inner courtyards. This shows that cooling effects in adjacent building blocks due to the greened urban park largely depend on the wind direction. The sensitivity tests show that the wind direction effect can result in local air temperature differences of up to 4 K on average. These results shows that even on summer days with low wind speeds, accurate wind direction data is highly relevant for accurate air temperature simulation. This finding can have important implications for urban planning and the design of green infrastructures in cities, e. g. for the design of fresh air corridors.

18 August 2022 in Advances in Science and Research
Verified
Journal Article
Open access
PDF file
NENils Eingrüber
Nils Eingrüber
WKWolfgang Korres
Wolfgang Korres
KSKarl Schneider
Karl Schneider
Cities are particularly affected by climate change impacts. Due to global warming, the frequency and intensity of summer heat events increases for many cities around the globe. Urban climatological studies have shown significant positive trends in the number of hot days and tropical nights. Heat stress is an important health as well as economic risk. Thus, urban planning needs to adapt to climate change. This requires a sound scientific analysis of different adaptation measures and management options, which must be based on appropriate data, models and scenarios to assess their suitability and efficacy. The goal of this paper is to assess the suitability of a low cost weather station network consisting of 33 NETATMO weather sensors and ultrasonic anemometers to measure air temperature, relative air humidity, wind speed and wind direction of a 16 ha study area in Cologne with high temporal and spatial resolution to support microclimatological modelling. The temperature and humidity sensors were calibrated against a research grade reference sensor under laboratory conditions. In addition, a research grade meteorological station (Campbell Sci.) was set up in the study area as a reference. The NETATMO sensors were placed to identify local microclimatic effects due to different surface types, vegetation and building structures. Using descriptive statistical analyses and pairwise comparisons, significant differences in the microclimatic conditions of the various sites were found, which can clearly be attributed to specific small scale microclimate factors. Significant differences were particularly identified comparing an avenue and a narrow street as well as a backyard and an urban park area. The sensors proved to provide data reliably and with suitable quality to measure microclimatic effects. The choice of sensors lends itself well for citizen participation, needed to facilitate climate change adaptation. In our further research, the data will be used as reference data for microclimatological modelling with ENVI-met investigating particularly options of mitigating climate change effects.

1 October 2020 in Earth System Science Data
Verified
Journal Article
Open access
PDF file
TRTim G. Reichenau
Tim G. Reichenau
WKWolfgang Korres
Wolfgang Korres
MSMarius Schmidt
Marius Schmidt
AGAlexander Graf
Alexander Graf
GWGerhard Welp
Gerhard Welp
KSKarl Schneider
Karl Schneider
The development and validation of hydroecological land-surface models to simulate agricultural areas require extensive data on weather, soil properties, agricultural management, and vegetation states and fluxes. However, these comprehensive data are rarely available since measurement, quality control, documentation, and compilation of the different data types are costly in terms of time and money. Here, we present a comprehensive dataset, which was collected at four agricultural sites within the Rur catchment in western Germany in the framework of the Transregional Collaborative Research Centre 32 (TR32) “Patterns in Soil–Vegetation–Atmosphere Systems: Monitoring, Modeling and Data Assimilation”. Vegetation-related data comprise fresh and dry biomass (green and brown, predominantly per organ), plant height, green and brown leaf area index, phenological development state, nitrogen and carbon content (overall > 17 000 entries), and masses of harvest residues and regrowth of vegetation after harvest or before planting of the main crop (> 250 entries). Vegetation data including LAI were collected in frequencies of 1 to 3 weeks in the years 2015 until 2017, mostly during overflights of the Sentinel 1 and Radarsat 2 satellites. In addition, fluxes of carbon, energy, and water (> 180 000 half-hourly records) measured using the eddy covariance technique are included. Three flux time series have simultaneous data from two different heights. Data on agricultural management include sowing and harvest dates as well as information on cultivation, fertilization, and agrochemicals (27 management periods). The dataset also includes gap-filled weather data (> 200 000 hourly records) and soil parameters (particle size distributions, carbon and nitrogen content; > 800 records). These data can also be useful for development and validation of remote-sensing products. The dataset is hosted at the TR32 database (https://www.tr32db.uni-koeln.de/data.php?dataID=1889, last access: 29 September 2020) and has the DOI https://doi.org/10.5880/TR32DB.39 (Reichenau et al., 2020).

28 June 2022
Verified
Conference Paper
Open access
NENils Eingrüber
Nils Eingrüber
KSKarl Schneider
Karl Schneider
WKWolfgang Korres
Wolfgang Korres
ULUlrich Löhnert
Ulrich Löhnert
Increasing heat exposure and heat stress due to global warming is a major problem in cities, and adaptation strategies to improve the urban microclimate are urgently needed. Successful climate change adaptation requires data, models and scenario analyses to evaluate the potentials and thermal effects of measures like green infrastructures, facade and roof greenings, shadings or light surfaces. In order to be able to estimate the effectiveness of different adaptation strategies in agglomeration areas, a physically-based 3D ENVI-met model was setup to simulate the urban microclimate of a 16 ha study area in Cologne Südstadt which is characterized by dense development in the east as well as an urban park area in the western part. In order to assess and test the model outputs, various sensitivity analyses were implemented, especially with regard to the effects of different meteorological forcing data. We compared the output data i) when using measured radiation (incoming direct and diffuse shortwave radiation and incoming longwave irradiance), and ii) when using measurements of the relative cloud cover of low-level, medium-level and high-level clouds as radiative forcing of the model. Radiation is measured with a diffusometer consisting of two pyranometers with and without a shadow ring and a pyrgeometer. The instruments are installed at our meteorological station (Campbell Scientific) in the urban park. The relative cloud cover for the different cloud levels is derived from the measurements of a close-by ceilometer. In addition to the sensitivity analyses, a model validation is carried out based on reference data of a densely distributed weather station network consisting of 33 NETATMO weather sensors and ultrasonic anemometers in the study area, which have previously been checked for long-term stability and consistency in the field and under laboratory conditions. On the basis of air temperature, relative humidity, wind speed and wind direction measurements, the quality of the ENVI-met model outputs is evaluated for statistical goodness of fit, and it is checked how accurate the ENVI-met model can represent and reproduce the actual measurements at the heterogeneous NETATMO test sites. The model validations and sensitivity analyses are accomplished for various typical weather conditions in order to show how the model quality differs between low-exchange high-pressure conditions and mixed weather conditions with different dominant wind directions. Further research will use this validated ENVI-met model to simulate and analyse the effects and potentials of various hypothetical adaptation measures taking into account climate change projections until 2099, and different scenarios will be compared in order to mitigate future heat stress and improve the urban microclimate.

15 May 2023
Verified
Conference Paper
Open access
NENils Eingrüber
Nils Eingrüber
KSKarl Schneider
Karl Schneider
WKWolfgang Korres
Wolfgang Korres
Extreme heat events are becoming more frequent in urban areas, and the magnitude of the urban heat island effect is increasing. Thus, adaptation of cities to climate change is a major challenge in urban planning. The summer of 2022 was the hottest summer in Germany on record. It was characterized by prolonged drought periods and low water levels in many rivers like the Rhine. For our urban study area in the city of Cologne (Germany), temperatures of more than 40°C were measured on several days, which is associated with excessive heat stress and health risks for the affected population. Significant small-scale temperature differences can be determined within cities for such heat events showing local effects and potentials for local adaptation and participation in climate change mitigation. As heat waves predominantly occur during radiation intensive and low-exchange weather conditions with limited or no advective air flow, microscale temperature differences can be traced back to the following most relevant processes: (1) differences in radiation absorption due to the albedo of urban surfaces, (2) shading effects by vegetation or buildings, (3 ) heat storage capacity and emissivity of materials, and (4) cooling effects through evapotranspiration of green infrastructures, urban water bodies, green facades or roofs. The aim of this study is to identify and explain small-scale microclimatic differences within a 16-hectare research area in the city of Cologne. Air temperature differences in a pedestrian level for two parallel streets with the same orientation and significant differences in terms of street width and greenery are analysed. We used the 3D ENVI-met model to simulate the urban microclimate of our study area with a spatial resolution of 1m² for the three hottest consecutive days which show the maximum 72-hour mean temperature in 2022 (July 18th-20th). The simulation results are validated using a densely distributed microclimate measurement network of 36 NETATMO low-cost sensors. The accuracy of these citizen science measurements is checked by three recalibration runs under laboratory conditions and direct comparisons with research-grade meteorological sensors in the field. The sensors show a high long-term stability and consistency with a measurement error less than one tenth of a Kelvin. ENVI-met model outputs and measurements are in very good agreement and show a high correlation. Thus, cause and effect relationships explaining the microclimatic conditions and its local deviations between the two selected streets can be made with high confidence during this heat wave in July 2022. Significant temperature differences of several Kelvin were identified when comparing the narrow, vegetation-free street canyon with the parallel broader street characterized by green front gardens, a double avenue of street trees and several facade greenings. Measured and modelled results show that local climate change adaptation measures can be highly effective in mitigating urban heat stress. In further steps, model scenarios will be developed to simulate and assess the potentials of various heat mitigation strategies in our study area in order to improve thermal outdoor comfort in cities with an increasing frequency of heat waves with over 40°C due to global warming.

6 July 2023
Verified
Conference Paper
Open access
NENils Eingrüber
Nils Eingrüber
ADAlina Domm
Alina Domm
WKWolfgang Korres
Wolfgang Korres
ULUlrich Löhnert
Ulrich Löhnert
KSKarl Schneider
Karl Schneider
Urban areas are particularly affected by climate change effects such as heat or droughts. The high percentage of dark and impervious surfaces leads to high radiation absorption and low evaporative cooling. Negative consequences for urban dwellers will significantly increase in future due to a higher frequency of extreme heat and drought events. At the same time, the high demand for new infrastructure and housing results in an increasing trend of sealed surfaces which is expected to continue in the next decades in many European agglomerations. To reconcile the requirements for climate change adaptation and urban development, strategies are needed to improve infiltration and evapotranspiration as well as decrease shortwave radiation absorption. Unsealed areas can 1) increase surface albedo in contrast to sealed asphalt or concrete roads and pavements, and 2) allow for bare-soil evaporation or evapotranspiration if vegetated, and thus increase latent heat flux and simultaneously reduce sensible heat flux. Furthermore, unsealed urban soils contribute keeping the water in the system of a city for longer time periods. This can reduce flooding and drought effects and improve the urban microclimate through more and longer-lasting evapotranspiration from unsealed soil water storages. Adaptation potentials and thermal effects of unsealing measures depend on many factors such as their size, structure or physical surface properties. The implementation of new unsealed areas is largely limited by urban structural constraints, development and traffic usage. Thus, adaptation potentials of different unsealing approaches must be assessed based on the given local conditions to achieve the best possible cooling effects during heat and droughts. Our study aims to investigate the effects of unsealing surfaces on the urban microclimate using scenario analyses. The high-resolution physically-based 3D ENVI-met model was used for a densely-developed residential research area in Cologne/Germany. The model simulations are driven by our local meteorological measurements and validated using our dense microclimate sensor network within the study area. To evaluate the potentials of various unsealing strategies on air temperature, permeable surfaces are parameterized and implemented in the setup model domain according to the given spatial constraints of the study area. Based on a simulation of the current sealed status quo, three unsealing scenarios are assessed: 1) natural bare-soil unsealings in traffic-free areas, 2) vegetated lawn unsealings in traffic-free areas, as well as 3) usage compatible unsealing measures in private spaces and low-traffic areas (courtyards, little frequented side streets, parking areas) by implementing grass grid pavers, while all main roads remain sealed. The model simulation results of the current situation are compared to the unsealing scenarios with respect to changes in the simulated air temperature. Significant differences were identified. These findings have important implications for urban planning aiming to mitigate future heat stress, droughts, flooding and improve thermal comfort.