Geophysical Engineering Department, Faculty of Civil, Planning and Geo Engineering, Institut Teknologi Sepuluh Nopember, Jalan Raya ITS, Sukolilo, Surabaya 60111, Jawa Timur
Auto-generated profile, based on publicly available information
Agnis Triahadini
Geophysical Engineering Department, Faculty of Civil, Planning and Geo Engineering, Institut Teknologi Sepuluh Nopember, Jalan Raya ITS, Sukolilo, Surabaya 60111, Jawa Timur
SUMMARY: Unzen volcano, located on Shimabara Peninsula, Nagasaki, Japan, is an active volcano that has been intensively monitored since 1989, one year before the most recent eruption in 1990–1995. Previous earthquake and surface deformation studies have revealed that magma is transported obliquely from a magma reservoir beneath Tachibana Bay, to the west of Shimabara Peninsula. Here, we conduct broad-band magnetotelluric (MT) surveys at 99 sites around Shimabara Peninsula to investigate the crustal structure beneath Unzen volcano that is related to magma migration. A 3-D resistivity model that is constructed from 25 broad-band MT sites and 45 telluric sites shows a broad high-resistivity zone beneath Shimabara Peninsula and low-resistivity zones to the west and east of the peninsula. An unexpected observation is the spatial alignment of the high-resistivity zone with a seismic low-velocity zone (LVZ) at 3–15 km depth. Quantitative analysis indicates this high-resistivity zone contains < 0.7 per cent melt under the assumption that the melt is stored in a good porosity network, while < 11 per cent melt in relatively poor pore network. We infer this high-resistivity, LVZ to be a highly crystallized mush zone (HCMZ) with low permeability. The hypocentres and pressure sources of the 1990–1995 eruption are distributed along the boundary between the high- and low-resistivity zones beneath the western part of the peninsula. We therefore conclude that the magma migrated along a structural boundary that possessed a relatively high permeability. Previous studies have suggested that eruptible magma is usually transported vertically upward through the centre of the mush zone, whereas the present results reveal that magma can be transported along the upper boundary of an HCMZ.
We conducted a broadband magnetotelluric (MT) survey along a north–south transect across Unzen graben, Japan. The MT survey line is located ~ 2 km west of the most recent lava dome and consisted of 27 stations along a 9-km profile. We estimated the 3-D resistivity structure and correlated it with the seismic reflection structure obtained by the same survey line as in the present study. The best-fit resistivity structure shows an upper resistive layer underlain by a moderately conductive layer. The resistive layer, which is interpreted as a cold groundwater zone, is cut by four faults marked by their relatively high conductivity. The underlying layer, which is interpreted as a hydrothermal-water-rich layer, also shows relatively conductive values near the faults. By assuming that the faults are imaged as relatively conductive zones, we infer the dip and depth extent of fracture zones around the faults. Beneath the Chijiwa Fault, which is the longest and most active fault of Unzen graben, the dominant conductor (C1) has a width of 2 km and extends down to below 4 km depth. C1 corresponds to a zone of strong seismic reflection and is located close to one of the pressure sources causing surface deformation. In this study, we interpret C1 as a network of fractures generated by the Chijiwa Fault to which magmatic volatiles are supplied from a deeper pressure source. Given that C1 extends to a greater depth and its resistivity is lower than other conductive zones, it is possible that earthquakes have occurred repeatedly on the Chijiwa Fault. In the center of the study area, we identify a vertically oriented body of high resistivity (R1) that corresponds to a zone of low seismic reflectivity. We interpret R1 as a cooled dyke complex that may have acted as a volcanic conduit.
7 January 2025 in Journal of Engineering and Technological Sciences
The Lembang Fault is one of the major faults in the province of West Java, approximately 10 km north of its capital, Bandung, a city inhabited by more than 2 million people. The fault exhibits distinct geometrical characteristics in its 29 km length, transitioning from normal, strike-slip, to vertical faulting mechanisms. Two studies have evidence of a normal fault with a dip direction to the north and a thrust fault with a dip direction to the south. Despite the lack of significant recorded earthquakes, the Lembang Fault is active and poses a high seismic hazard to the surrounding region. Previous deformation studies estimate that the fault could produce earthquakes of magnitude 6.7 to 7.0, though these estimates do not account for the fault's unique geometry, which includes bends at both its eastern and western ends. This geometrical complexity can significantly affect slip distribution, potentially leading to over- or underestimating earthquake magnitude. In this study, we assess the earthquake potential of the Lembang Fault using 3D dynamic rupture simulations that incorporate the fault's geometrical complexity, 3D velocity structure, and plastic deformation. Our simulations indicate that the fault's complex geometry enhances rupture slip to the east while halting it to the west, resulting in rupture along 80% of the fault's total length. However, according to our model, a self-sustained runaway rupture scenario occurs only if the fault is characterized by relatively weak apparent strength, subcritical stress, and overpressurization. This worst-case scenario could result in a magnitude 7.0 earthquake, posing a significant threat to the densely populated nearby city. Therefore, our findings have crucial implications for seismic hazard assessment around the Lembang Fault.
Unzen Volcano is located in Shimabara Peninsula, Nagasaki, Japan. After 198 years of dormancy, the volcano erupted throughout 1990-1995 and resulted the emergence of new lava dome called Heisei-Shinzan. Following the eruption, numerous studies have been intensively conducted in Unzen volcano to assess the eruption mechanism and the magma plumbing system. Regarding to the magmatic system, the most preferred model is that the primary supply of magma is stored beneath Chijiwa bay. This magma chamber is located about 15 km west of the active dome at vertical depth approximately 15 km, and followed by subordinate shallower magma chambers beneath the volcano (e.g. Nakamura 1995; Kohno et al 2008). Upon the eruption, the magma ascended obliquely towards the summit in east direction (e.g. Umakoshi et al 2001). However, how main magma chamber and shallower chambers are connected to the summit via oblique pathway is poorly imaged in terms of structure.As widely known, Magnetotelluric method is highly sensitive to low resistivity zone caused by interconnected fluids. Low resistivity zone detected in the volcanic area usually can be interpreted as hydrothermal/magmatic fluid and or magma chamber containing partial melt (e.g. Aizawa et al 2014; Hill et al 2015). Thus, by using broadband Magnetotelluric method, we aim to investigate resistivity structure of Unzen volcano associated with magmatic system and its controlling structure (e.g. pathway and faults).Although the shallow structures around Unzen volcano are estimated by the 2017-2019 campaigns (Triahadini et al 2019; Hashimoto et al 2020), we are unable to image deeper structure around the proposed location of magma chambers and magma pathway. To achieve our goals, during November-December 2020, we installed 35 new sites to cover whole area in Shimabara Peninsula. In total, deployed 99 Magnetotelluric stations covering Unzen volcano and Shimabara Peninsula. On this meeting, we would like to present our resistivity structure derived from all dataset.