22 September 2021 in IEEE Transactions on Industrial Electronics
This article is based on an experimental study on the aerodynamic performance of a flapping wing rotor (FWR) and enhancement by passive pitching angle variation (PPAV) associated with powered flapping motion. The PPAV (in this article, 10 o –50 o ) is realized by a specially designed sleeve-pin unit as part of a U-shape flapping mechanism. Through experiment and analysis, it is found that the average lift produced by an FWR of PPAV is >100% higher than the baseline model, the same FWR of a constant pitching angle 30 o under the same input power. It is also noted that the lift–voltage relationship for the FWR of PPAV is almost linear and the aerodynamic efficiency is also over 100% higher than the baseline FWR when the input voltage is under 6 V. The aerodynamic lift or efficiency of the FWR of PPAV can be also increased significantly by reducing the weight of the wings. An FWR model is fabricated and achieved vertical take-off and free flight powered by 9 V input voltage. The mechanism of PPAV function provides a feasible solution for aerodynamic improvement of a bioinspired FWR and potential application to micro air vehicles.
25 February 2012 in Chinese Journal of Mechanical Engineering
Morphing wing has attracted many research attention and effort in aircraft technology development because of its advantage in lift to draft ratio and flight performance. Morphing wing technology combines the lift and control surfaces into a seamless wing and integrates the primary structure together with the internal control system. It makes use of the wing aeroelastic deformation induced by the control surface to gain direct force control through desirable redistribution of aerodynamic forces. However some unknown mechanical parameters of the control system and complexity of the integrated structure become a main challenge for dynamic modeling of morphing wing. To solve the problem, a method of test data based modal sensitivity analysis is presented to improve the morphing wing FE model by evaluating the unknown parameters and identifying the modeling boundary conditions. An innovative seamless morphing wing with the structure integrated with a flexible trailing edge control system is presented for the investigation. An experimental model of actuation system driven by a servo motor for the morphing wing is designed and established. By performing a vibration test and the proposed modal sensitivity analysis, the unknown torsional stiffness of the servo motor and the boundary condition of the actuation mechanism model is identified and evaluated. Comparing with the test data, the average error of the first four modal frequency of the improved FE model is reduced significantly to less than 4%. To further investigate the morphing wing modeling, a wing box and then a whole morphing wing model including the skin and integrated with the trailing edge actuation system are established and tested. By using the proposed method, the FE model is improved by relaxing the constraint between the skin and actuation mechanism. The results show that the average error of the first three modal frequency of the improved FE model is reduced to less than 6%. The research results demonstrate that the presented seamless morphing wing integrated with a flexible trailing edge control surface can improve aerodynamic characteristics. By using the test data based modal sensitivity analysis method, the unknown parameter and boundary condition of the actuation model can be determined to improve the FE model. The problem in dynamic modeling of high accuracy for a morphing wing can be solved in an effective manner.
26 April 2022 in Biomimetic Intelligence and Robotics
1 January 2016 in International Journal of Information and Education Technology
12 July 2025 in Journal of Bionic Engineering