Hua Qin

Hua Qin

Auto-generated profile, based on publicly available information

Hua Qin

Department of Electrical and Computer Engineering University of Wisconsin-Madison 1415 Engineering Drive Madison WI-53706 USA

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 November 2005 in New Journal of Physics
Verified
Journal Article
Open access
PDF file
HQH Qin
H Qin
NSN Shaji
N Shaji
NMN E Merrill
N E Merrill
HKH S Kim
H S Kim
RTRyan Toonen
Ryan Toonen
GCG Celler
G Celler
We report the formation of micrometre-sized SiGe/Si tubes by releasing strained SiGe/Si bilayers from substrates in a wet chemical-etching process. In order to explore statistical studies of dynamic formation of microtubes, we fabricated arrays of square bilayers. Due to the dynamic change in curvature of the bilayers, and hence the underlying etch channels, the etching process deviates from a transport-controlled regime to one of kinetic controlled. We identified two distinct modes of etching. A slow etching mode is associated with symmetric surface deformation in which the bilayers mostly retain their initial pattern. In the fast mode, bilayers are asymmetrically deformed while large etch channels are induced and etching becomes kinetically controlled. Etch rate dispersion is directly related to the degree of asymmetry in surface deformation. When the dimensions of the bilayers become significantly larger than the curvature radius, kinetic etching dominates. During the formation of tubes, SiGe/Si bilayers strongly interact with the liquid environment of etchant and solvent. Assisted by the surface tension of evaporating liquids, the tubes are drawn near the substrate and eventually fixed to it because of van der Waals forces. Our study illuminates the dynamic etching and curling processes involved with and provides insight on how a uniform etch rate and consistent curling directions can be maintained.

18 August 2007 in arXiv
Verified
Preprint
Open access
PDF file
HQHua Qin
Hua Qin
HKHyun-Seok Kim
Hyun-Seok Kim
RBRobert H. Blick
Robert H. Blick
A new transmission-type electron multiplier was fabricated from silicon-on-insulator (SOI) material by integrating an array of one dimensional (1D) silicon nanopillars onto a two dimensional (2D) silicon membrane. Primary electrons are injected into the nanopillar-membrane system from the flat surface of the membrane, while electron emission from the other side is probed by an anode. The secondary electron yield (SEY) from nanopillars is found to be about 1.8 times that of plane silicon membrane. This gain in electron number is slightly enhanced by the electric field applied from the anode. Further optimization of the dimensions of nanopillars and membrane and application of field emission promise an even higher gain for detector applications and allow for probing of electronic/mechanical excitations in nanopillar-membrane system excited by incident particles or radiation.

18 August 2007 in arXiv
Verified
Preprint
Open access
PDF file
HQHua Qin
Hua Qin
DWDavid A. Williams
David A. Williams
We fabricate and characterize a radio-frequency semiconductor point-contact electrometer (RF-PC) analogous to radio-frequency single-electron transistors [RF-SETs, see Science {\bf 280}, 1238 (1998)]. The point contact is formed by surface Schottky gates in a two-dimensional electron gas (2DEG) in an AlGaAs/GaAs heterostructure. In the present setup, the PC is operating as a simple voltage-controlled resistor rather than a quantum point contact (QPC) and demonstrates a charge-sensitivity about $2\times 10^{-1} \mathrm{e/\sqrt{Hz}}$ at a bandwidth of $30 \mathrm{kHz}$ without the use of a cryogenic RF preamplifier. Since the impedance of a typical point-contact device is much lower than the impedance of the typical SET, a semiconductor-based RF-PC, equipped with practical cryogenic RF preamplifiers, could realize an ultra-fast and ultra-sensitive electrometer.

27 August 2007 in arXiv
Verified
Preprint
Open access
PDF file
HQHua Qin
Hua Qin
HKHyun-Seok Kim
Hyun-Seok Kim
MWMichael S. Westphall
Michael S. Westphall
LSLloyd M. Smith
Lloyd M. Smith
RBRobert H. Blick
Robert H. Blick
We report on strongly enhanced electron multiplication in thin silicon membranes. The device is configured as a transmission-type membrane for electron multiplication. A sub-threshold electric field applied on the emission side of the membrane enhances the number of electrons emitted by two orders of magnitude. This enhancement stems from field emitted electrons stimulated by the incident particles, which suggests that stacks of silicon membranes can form ultra-sensitive electron multipliers.