27 September 2022 in Mobile Information Systems
Multilink operation (MLO) is considered a key candidate technique in 802.11be, which allows devices to transmit and receive data using multiple links concurrently, thereby contributing to improving throughput and reducing latency. However, the performance of the MLO scheme will gradually degrade as the channel environment deteriorates. To tackle this problem, in this paper, we propose a synchronous multilink media access control (MAC) protocol with Automatic Repeat Request (called SML-ARQ). With SML-ARQ, in the contention process, MLDs are allowed to perform channel access procedures over multiple links concurrently; in the transmission process, MLDs partition a link packet into multiple blocks and then transmit these blocks using multiple links. Any failed division of a link packet is copied and retransmitted once using multiple channels concurrently; as a consequence, SML-ARQ can mitigate the adverse impact of transmission failure on system performance. A theoretical model is being developed to analyze the performance of the proposed SML-ARQ. Extensive simulations verify the efficiency of SML-ARQ and the accuracy of our theoretical model.
18 August 2021 in IEEE Access
In traditional CSMA/CA-based MAC designs supporting successive interference cancellation (SIC), channel utilization is inefficient, because the inherited CSMA/CA-style contention approach often forces the whole channel to remain idle and the early released channel is not utilized. In this paper, we propose Multi-CQ, which is the first software-defined networking (SDN)-based MAC design for wireless LANs that supports SIC and significantly improves the channel utilization. Multi-CQ, adopting SDN's functional separation idea and OFDMA, makes contention and data transmission be executed over two subchannels independently and concurrently, where the superposition coding are used for decoding combined signals, and multiple CQs (contention queues) are introduced to coordinate the concurrency. This concurrent execution greatly reduces the waste in channel contention. Next, adopting SDN's central control idea, Multi-CQ controller selects nodes who can finish their frame transmissions in almost equal time, thereby improving the channel utilization. Finally, we develop a theoretical model to optimize bandwidth allocation for channel contention and data transmission. Extensive simulations verify the effectiveness of our design and the accuracy of our theoretical model. This study is also helpful to better design wireless MAC protocols supporting other advanced functionalities such as MU-MIMO.
31 October 2023 in IEEE Internet of Things Journal
Conventional wireless networks are half-duplex and most of them use contention-based protocols. These protocols usually adopt a principle of contention with collision avoidance and infer a collision occurrence very late from the absence of an acknowledgment after data transmission, causing low network performance. Wireless full-duplex (FD) enables simultaneous transmission (TX) and reception (RX) on the same channel. Exploiting this functionality, this article proposes the first design that enables contention with collision detection (CCD) to improve the network performance. We call the proposed design FD-CCD. With FD-CCD, in contention, a node exploits the TX antenna to transmit a signal for channel contention, while exploiting the RX antenna to sense if other nodes are transmitting too. By checking the status of the TX and RX antennas, the node can detect the contention collision before data transmission and, hence, obtain an opportunity to avoid the data collision effectively. FD-CCD also supports priority-based contentions, is of very low contention overhead, and is compatible with conventional 802.11 networks. This article then develops a theoretical model to analyze the system performance and optimize protocol parameter settings. Extensive simulations verify the effectiveness of our design and the accuracy of our model. This study is very helpful in designing efficient FD protocols.