18 March 2025 in IEEE Journal of Solid-State Circuits
This article presents a low-jitter sub-sampling chopper phase-locked loop (SS-CPLL) that incorporates a novel chopping charge pump (C-CP) to mitigate 1/f noise in short-channel devices operating at a low supply voltage of 0.75 V. A charge-share cancellation technique is introduced to suppress ripple generated by residual charge from the previous reference period. The chopping modulation further reduces the charge pump’s white noise by filtering out high-order harmonics of folded noise, thereby significantly lowering in-band noise. In addition, a high-swing class-C/F2 voltage-controlled oscillator (VCO) is proposed to optimize out-of-band noise while maintaining low power consumption. Fabricated in 65-nm complementary metal oxide semiconductor (CMOS) with a core area of 0.64 mm2, the SS-CPLL achieves an in-band phase noise of -111.9 dBc/Hz at 1-kHz offset, an integrated jitter of 49.9 fs, and a figure-of-merit (FoM) of -257.1 dB at 9 GHz, while consuming 7.8 mW of power. The proposed SS-CPLL reduces in-band noise by approximately 15 dB compared with a conventional sub-sampling phase-locked loop (SSPLL), while maintaining a similar reference spur level of -58 dBc/Hz. This highlights the effectiveness of the C-CP and charge-share cancellation techniques.
22 February 2024 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief presents a 73-dB-SNDR 2nd-order noise-shaping successive approximation-register (NS-SAR) analog-to-digital converter (ADC) with a low-noise time-domain comparator. In contrast to most prior works, in which a multi-input voltage-domain comparator was adopted as a signal summation circuit, the proposed NS-SAR employs a time-domain comparator to sum signals, which reduces input-referred noise by increasing the number of voltage-controlled delay stages, exhibiting high noise efficiency. Fabricated in a 65-nm CMOS process, the prototype 6-bit NS-SAR ADC achieves a peak signal-to-noise and distortion ratio (SNDR) of 73 dB over a bandwidth of 250kHz with an oversampling ratio (OSR) of 20, while consuming only 93.85 úW from a 1 V supply, leading to an SNDR-based Schreier figure of merit (FoM) of 167.3 dB.
11 April 2023 in IEEE Microwave and Wireless Technology Letters
This letter reports a transformer-feedback voltage-controlled oscillator (VCO) (TF-VCO) with separated differential-mode (DM) and common-mode (CM) resonance for feasibility and low phase noise. With an effort to isolate the DM and CM resonances by the relatively DM resonance-independent single-ended (SE) capacitors connected at NMOS source for CM tuning and a CM cancellation transformer between drain and source, the proposed VCO achieves low resonant frequency interaction between CM and DM resonances. A factor $ F_{\rm cm,dm}$ is defined to describe this interaction. Compared with the other mainstream implicit CM resonance oscillators, the proposed VCO exhibits at least 7.75 times better $F_{\rm cm,dm}$ . Implemented with the 180-nm CMOS process, the 6-GHz VCO occupies a die area of 0.1 $\rm {mm^2}$ and consumes 6 mW under 750-mV supply. The measurement result demonstrates a phase noise of $-$ 123.7 dBc/Hz at 1-MHz offset with a $-$ 191.5 dBc/Hz peak figure-of-merit (FoM) and only undergoes 0.21% frequency shift after calibrated harmonic tuning.
5 December 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
Energy-efficient and cost-effective wireless connectivity is of paramount importance for Internet-of-Things (IoT) applications and has inspired a lot of research interests lately. Reuse techniques at both the transceiver architecture and functional RF circuit levels are especially attractive as they aim to break the trade-off between power, performance and cost, while retaining compliance with the dedicated IoT communication standard. This tutorial presents a review of the widely adopted “current reuse” and “RF-I/O reuse” techniques in RFIC design and the recent design trends towards “function reuse”, “area reuse” in support for low power IoT.
30 June 2025 in IEEE Transactions on Circuits and Systems II: Express Briefs
This paper presents a sub-sampling-chopper (SSCPLL) that incorporates a chopper-stabilized phase detector (PD) and charge pump (CP), along with a novel low-power, residual-free charge-share-canceling (RF-CSC) scheme. It features: Firstly, a cross-coupled pre-charging across two chopping phases to fully nullify residual charge-sharing by compensating inter-cycle voltage differences. Secondly, a reset mechanism that minimizes charge compensation per clock cycle, reducing dynamic power consumption. Fabricated in 65-nm CMOS technology, the RF-SS-CPLL occupies an active area of 0.37mm2. Operating at 9-GHz with a 100 MHz reference input, it achieves 39-fs integrated jitter (1 kHz-100 MHz) and -69.78dBc reference spurs, yielding a jitter-power figure of merit (FoMJ) of -258.24dB.
7 May 2025 in Microwave and Optical Technology Letters