Jung-Hyun Moon

Jung-Hyun Moon

Auto-generated profile, based on publicly available information

Jung-Hyun Moon


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 October 2021 in Journal of Power System Engineering
Verified
Journal Article
Closed access
JMJung-Hyun Moon
Jung-Hyun Moon
HLHo-Saeng Lee
Ho-Saeng Lee
JSJongbeom Seo
Jongbeom Seo
In accordance with the regulations of the International Maritime Organization (IMO), ships in operation need measures such as reducing carbon emissions and improving ship efficiency. In response to these regulations, a number of studies on a system for recovering a large amount of waste heat generated from the engine of a ship are in progress. In this study, an organic Rankine cycle (ORC), a promising waste heat recovery system, was designed using a low-temperature cooling water that passed through the vessel’s scavenge air cooler (SAC) as a heat source. Simulations were conducted on gross power, net power and efficiency. The working fluid is R134a. When the turbine inlet pressure was varied from 8.5 bar to 12.5 bar, the maximum net power was shown around 10.5 bar.

28 February 2022 in Journal of Power System Engineering
Verified
Journal Article
Closed access
LSLim seungtaek
Lim seungtaek
HLHo-Seang Lee
Ho-Seang Lee
JMJung-Hyun Moon
Jung-Hyun Moon
YSYoungkyun Seo
Youngkyun Seo
In order to analyze the fuel consumption of eco-friendly ships promoting ammonia fuel, which is currently being developed due to increasing international demand for alternatives of environmental pollution causing ships, a modeling of fuel consumption analysis has been analyzed in this study. Modeling of fuel consumption analysis has been applied to a pre-existing ammonia transporting ship to figure out HFO consumption according to engine output. The applied ship, a 16,080 kW class model crossing the United States and Europe, showed a fuel consumption of 2,714 kg/h at 100% load. In the meantime, ammonia fuel conversion rate of 2.2 was applied to confirm the maximum fuel amount of 5,909 kg/h and the consumption per output of 368.9 g/kWh based on the same engine power. Moreover, an additional analysis of the fuel consumption and storage capacity regarding the operating speed and route were analyzed. In the case of the load change rate of the diesel engine applied to the ammonia engine, the smallest SFOC of 360.0 g/kWh at 75% of the load was shown and the fuel consumption was about 4,336.9 kg/h. In the case of the route from the US to UK, with 30% portion of maximum load applied, fuel consumption of 1,837,000 kg/h and volume of 2,816.6 ㎥ were required for the fuel consumption analysis. Results of this study will be used for further fuel consumption analysis of operational characteristics in the future.

31 August 2022 in Journal of Power System Engineering
Verified
Journal Article
Closed access
JMJung-Hyun Moon
Jung-Hyun Moon
LSLim seungtaek
Lim seungtaek
HLHo-Saeng Lee
Ho-Saeng Lee
KHKim Hyeon-ju
Kim Hyeon-ju
Due to industrialization and urbanization, the energy used by humankind is rapidly increasing, and side effects such as global warming and climate change are appearing. In order to respond to these international problems, research on new and renewable energy is continuously being carried out. In this study, OTEC-Heat pump combined cycle for domestic application was studied.BR Electricity was produced by OTEC through the increased surface water temperature and direct cooling using deep water discharge water in the summer were constructed. A heat pump using seawater is at higher temperature than outside air in the winter. In this study, energy cost and carbon dioxide emissions were compared with existing diesel power generation, EHP cooling, and kerosene heating systems. By applying OTEC, it was possible to produce 757.7 MWh of electricity per year, and through direct cooling, it was possible to save 98% of energy compared to EHP and 82% of energy compared to kerosene heating through a seawater heat pump.

31 October 2020 in Journal of Power System Engineering
Verified
Journal Article
Closed access
JMJung-Hyun Moon
Jung-Hyun Moon
HLHo-Saeng Lee
Ho-Saeng Lee
LSLim seungtaek
Lim seungtaek
JSJongbeom Seo
Jongbeom Seo
KHKim Hyeon-ju
Kim Hyeon-ju

30 April 2020 in Journal of Power System Engineering
Verified
Journal Article
Closed access
LSLim seungtaek
Lim seungtaek
HLHo-Seang Lee
Ho-Seang Lee
JMJung-Hyoen Moon
Jung-Hyoen Moon
HKHyoen-Ju Kim
Hyoen-Ju Kim
As a means to solve the power shortage problem in the South Pacific island nations and the equator, we studied the development characteristics of ocean thermal energy conversion (OTEC) using near-infinity clean ocean energy. Through the simulation of the closed OTEC plant under development, the generation amount and its economic efficiency were compared and the application characteristics of the power generation cycle according to the seawater temperature distribution were compared by applying various seawater temperature conditions. According to the characteristics of seawater heat sources in the region, the power generation output was about 759.9 kW in Kiribati, and the average power generation by region was about 590.9 kW. Regional electricity sales generated about 8,487 thousand dollars in Kiribati, which had a high power cost of 0.327 $/kWh, and 1,278 thousand dollars in Australia, generating 0.29 $/kWh. With the spread of 50 MW commercial plants, Australia and Kiribati have high net present values (NPV) of 108,000 and 580,000 thousand dollars, respectively, and their internal rate of return (IRR) are more than 8.5% and 19.6%, respectively. In the future, various benefits will be applied to secure economic feasibility and accelerate the spread of closed OTEC plant.

30 April 2016 in Journal of Power System Engineering
Verified
Journal Article
Open access
HLHo-Saeng Lee
Ho-Saeng Lee
JMJung-Hyun Moon
Jung-Hyun Moon
KHKim Hyeon-ju
Kim Hyeon-ju