Faculty 3 Mechanical Engineering, Electrical and Energy Systems, Brandenburg University of Technology Cottbus–Senftenberg (BTU), 03046 Cottbus, Germany
Auto-generated profile, based on publicly available information
Holger Seidlitz
Faculty 3 Mechanical Engineering, Electrical and Energy Systems, Brandenburg University of Technology Cottbus–Senftenberg (BTU), 03046 Cottbus, Germany
The paper presents the current volume of international production and global markets of carbon fiber reinforced polymer composites, also regarding the potential development trends. Examples were provided on how to effectively recycle carbon fiber reinforced polymer composites. Legally binding legislation in the EU on polymer composite recycling was given.
The paper presents some examples of new technological solutions for the recovery and re-use of recycled carbon fiber in automotive and railway industries, as well as in aviation and wind turbine constructions. The new technologies of fiber recovery that are described can enable the mass-scale use of recycled carbon fiber in the future.
1 September 2019 in Composites Part B: Engineering
The development of a new joining technology, which is used to manufacture high strength hybrid constructions with thermoplastic composites (FRP) and metals, is introduced. Similar to natural regulation effects at trees, fibers around the FRP joint become aligned along the lines of force and will not be destroyed by the joining process. This is achieved by the local utilization of the specific plastic flow properties of the FRT and metal component. Compared with usual joining methods—such as flow drill screws, blind and self-piercing rivets—noticeably higher tensile properties can be realized through the novel process management. The load-bearing capability increasing effect could be proved on hybrid joints with hot-dip galvanized steel HX420LAD and orthotropic glass—as well as carbon—fiber reinforced plastics. The results, which were determined in tensile-shear and cross-shear tests according to DIN EN ISO 14273 and DIN EN ISO 14272, are compared with holding loads of established joining techniques with similar joining point diameter and material combinations.
16 January 2018 in Technologies for Lightweight Structures (TLS)
Organic sheets made of fiber-reinforced thermoplastics can make a crucial contribution to increase the lightweight potential of a technical design. They show high specific strength- and stiffness properties as well as good damping characteristics, while being able to show a higher energy absorption capacity than comparable metal constructions. In addition, organic sheets provide good recycling capabilities. Nowadays, multi-material designs are an established way in the automotive industry to combine the benefits of metal and fiber-reinforced plastics (FRP). Currently used technologies for the joining of organic sheets and metals in large-scale production are mechanical joining and adhesive technologies. Both require large overlapping areas to achieve the desired joint strength and stiffness of the technical design. Additionally, mechanical joining is usually combined with “fiber-destroying” pre-drilling and punching processes. This will disturb the force flux at the joint zone by causing unwanted fiber- and inter-fiber failure and inducing critical notch stresses. Therefore, the multi-material design with fiber-reinforced thermoplastics and metals needs optimized joining techniques that don’t interrupt the force flux, so that higher loads can be induced and the full benefit of the FRP material can be used. This article focuses on the characterization of a new joining technology, based on the Cold Metal Transfer (CMT) welding process, that allows to join organic sheets and metals in a load path optimized design. This is achieved by realigning the fibers around the joint zone by the integration of a thin metal pin. The alignment of the fibers will be similar to load paths of fibers inside structures found in nature. A tree with a knothole is always going to align its fibers in principle stress direction. As a result of the bionic fiber design, high joining strengths can be achieved. The increase of the joint strength compared to blind riveting was performed and proven with stainless steel and orthotropic reinforced composites in tensile shear-tests, based on the DIN EN ISO 14273.