This paper presents a condition assessment and an analysis of the degradation causes for the road bridge over the Nišava River near the village of Vrandol, in the municipality of Bela Palanka. The structure represents a specific modification of the „Karpoš“ precast system, where steel wagon-type beams were utilized for the superstructure alongside standard substructure elements – specifically, precast piles. Through field investigation and macroscopic inspection, a critical structural condition was identified, primarily caused by the loss of stability in the substructure. Due to the impact of debris and ice, significant deviations from the vertical alignment were observed in the reinforced concrete conical piles. These geometric imperfections induced substantial parasitic stresses within the columns and main girders. Coupled with evident corrosion of the steel elements and degradation of the deck slab due to inadequate drainage, the bridge’s load capacity has been reduced below safety limits. This paper categorizes the recorded damages and proposes urgent rehabilitationl measures, while recommending a temporary traffic ban to prevent structural collapse.
The subject of this paper is the vibration analysis of steel beams with hexagonal web openings. In addition to verifying the limit states of existing structures where new web openings are introduced, beams with web openings are also used in newly planned structures. This paper presents a comparative analysis of serviceability limit state calculation methods according to the methods provided in prEN 1993-1-13. A comparative calculation of natural frequencies of oscillation is analyzed, as this represents the main parameter for assessing structural vibrations.
The second generation of Eurocode 5 is in preparation and has not yet been adopted, so the calculation of the load-carrying capacity of timber-steel connections is based solely on the rules of the first generation. Currently, load-carrying capacity is determined using expressions for thin or thick steel plates. For cases in between, linear interpolation is used. The thickness and mechanical properties of the steel plate significantly influence the behaviour of the timber-steel connection, which is why research in this field focuses on improving the expressions for the connection capacity. The aim is to define the failure modes more precisely and determine the connection capacity more accurately. This paper shows how Johansen’s expressions for timber-timber connections can be adjusted for steel-timber connections by accounting for the previously mentioned parameters.