An examination on root characteristics and root properties has been implemented in this study. Two types of bioengineering were chose which are Vetiver grass and Bermuda grass as these grasses were widely applied for slope stabilization. The root samples were taken to the laboratory to investigate its classification, characteristics and strength. The root of both grasses was found grow with fibrous root matrix system. In terms of root anchorage, the root matrix system of Vetiver grass was exhibits more strengthen than the Bermuda grass. However, observation on root image from Scanning Electron Microscope test reveals that the root of Vetiver grass becomes non-porous as the moisture content reduced. Meanwhile, the root tensile strength of Bermuda grass was obtained acquired low value with higher percentage of moisture content, root morphology and bonding strength. The results indicated that the root tensile strength is mainly influence by percentage of moisture content and root morphology.
The failure mode limitations presented in the International Society for Rock Mechanics (ISRM) were recognised as an obvious issue by invalidating most of the failure modes along the bedding plane. In this study, the anisotropic behaviour of index strength and failure mode of weathered shale are evaluated by utilising the point load test (PLT) and the block punch index (BPI). The outcomes elaborate that the degree of anisotropy of PLT is four times the BPI degree of anisotropy. The failure mode of weathered shale is observed to be controlled by the bedding plane orientation (β). Particularly, when the point loading is not perpendicular to the bedding plane orientation, it is necessary to consider the inclined failure mode along bedding since eliminating these results may cause a significant over-prediction of index strength. Meanwhile, the presence of secondary failures along a bedding in weathered shale under BPI is because of the normal stress distribution. Consequently, the very low bonding between the bedding planes is not able to resist the tensile stresses developed at the specimen faces during punching. The study also highlighted the effect of the horizontal angle of bedding orientation (θ) with respect to the puncher.