19 June 2023 in Journal of Physics D: Applied Physics
InAs quantum dot ridge waveguide lasers comprising single-port multi-mode-interference-reflectors (MMIR) and single-cleaved reflectors are designed, fabricated, and characterised, to demonstrate capability for optoelectronic-integrated-circuits. Simulations of an MMIR show high values of fundamental mode reflectivity ( and good selectivity against higher order modes. Deep-etched MMIR lasers fabricated with 0.5 mm long cavities have a threshold current of 24 mA, compared to 75 mA for standard Fabry–Perot cleaved–cleaved FP-RWG lasers of the same length, both at 25 °C, and 56 mA compared to 102 mA at 55 °C. MMIR lasers exhibit stable ground state operation up to 50 °C and show promise as small footprint sources for integrated photonics.
14 April 2025 in IEEE Photonics Journal
We demonstrate high temperature operation of InAs quantum dot lasers through active region engineering. We grew an n-doped region within the InAs quantum dot (QD) layer and incorporated a 10 nm p-GaAs modulation-doped layer within a 43 nm GaAs spacer layer, both of which are essential components of the active region of the InAs QD laser device. The co-doping scheme enables the demonstration of InAs QD laser device with only seven layers of InAs QDs in the active region for high temperature operation, which is compared with a conventional undoped InAs QD laser device. A Fabry-Pérot laser device with as-cleaved facets and a co-doped InAs QD active region enables ultra-high temperature pulsed-biased O-band laser operation up to 202 °C, compared to 180 °C for conventional undoped InAs QD laser, and without requiring high-reflective facet coatings.
4 December 2025 in Optics Express
The design of gain chips for hybrid integration with photonic integrated circuits (PICs) is studied and highlights the benefits of incorporating at least one reflector in the III-V gain material. Quantum dot (QD)-based gain chips with a multi-mode interference (MMI) reflector (MMIR) offer fabrication simplicity and good performance in the O-band. The inclusion of an MMIR in a ridge waveguide (RWG) laser reduces the threshold current by 87% (6 mA vs 46 mA for 1 mm length) and leads to higher slope efficiency, indicating over 90% mirror reflectivity, as compared to Fabry-Perot structures. Both 1- and 2-port designs will simplify alignment of active and passive waveguides for hybrid integration and are strong candidates for large-scale PIC applications.
24 June 2025 in Journal of Physics D: Applied Physics
A straightforward method to achieve monolithic selective area intermixing in an epitaxially grown InAs quantum dot (QD) based laser structure is demonstrated, enabling the development of O-band monolithic photonic integrated circuits. Blue shifts of up to 37 nm are demonstrated in electrically biased laser diode wavelength and photoluminescence measurements. Significantly reduced absorption by up to 38 cm−1, measured by the segmented contact technique, in the wavelength range of 1220 nm – 1320 nm is achieved for selectively intermixed compared to unintermixed samples. For achieving the selectivity and reduced absorption, hydrogen proton bombardment with a 7° angle and doses of 5 × 1012 cm−2 and 5 × 1013 cm−2 and 300 keV energy is used to create defect sites within the InAs QD based active region followed by rapid thermal annealing with a ∼200 nm SiO2 capping layer as a simple means to tune the bandgap. This work establishes the viability of selective area band-gap-tuning in InAs QD laser epitaxy for low loss monolithic III–V photonic integration.