5 August 2021 in Optics Express
Here we demonstrated an efficient high-power single-frequency thulium-doped fiber ring laser operating at 1720 nm. Three cascaded sub-rings were inserted into the main cavity to significantly enlarge the effective free spectral range. By incorporating a fiber Bragg grating, the single longitudinal mode operation was achieved. The maximum single-frequency output power reached up to 1.11 W under 3.75-W launched pump power, while the slope efficiency with respect to the absorbed pump power was 46.4%. The laser linewidth at maximum single-frequency power was measured of 1.9 kHz. Potential power scaling of the single-frequency output power with different quantity and lengths of the sub-rings was also theoretically investigated.
23 June 2021 in Optics Express
The single-frequency operation of a thulium fiber laser at a short wavelength of 1720 nm is investigated in a ring resonator. Powerful single-longitudinal-mode operation was realized by utilizing an unpumped thulium-doped fiber as the saturable absorber. The fiber laser delivered 407 mW single-frequency output with a spectral linewidth of 4.4 kHz under 2.7-W launched pump power at 1570 nm, which turned to multi-longitudinal-mode operation at higher pump powers. Additionally, optical bistability of both output power and longitudinal mode behavior, originating from the saturable absorption effect, were observed and discussed. To the best of our knowledge, this is the first efficient 1.7-μm single-frequency fiber laser as well as the first demonstration of optical bistability in thulium-doped fiber lasers.
19 January 2023 in Optics Letters
A high-power, high-efficiency single-frequency fiber laser at 1064 nm was demonstrated based on a distributed Bragg reflector (DBR) all-silica-fiber configuration. A single-frequency laser with an output power of 642 mW and slope efficiency of 66.4% with respect to absorbed pump power was achieved from a 1.2-cm-long commercially available Yb3+-doped silica fiber. To the best of our knowledge, this is the highest single-frequency laser power and efficiency obtained from the DBR all-silica fiber laser. The work presented here paves the way for the development of high-power, robust, and cost-effective single-frequency Yb3+-doped all-silica fiber lasers.
29 July 2022 in Optics Letters
We demonstrate an efficient single-frequency Tm-doped fiber laser at 2050 nm. A ring cavity scheme is employed to boost the net gain at the wavelength. A piece of Tm/Ho-codoped fiber with an absorption coefficient at 2050 nm higher than that of a Tm-doped fiber is used to establish the dynamic Bragg grating for enhancing the frequency selection capability. A single-frequency output of 215 mW is obtained under 2 W of 1570-nm pump power, with the slope efficiency being 22%. To the best of our knowledge, this is the highest single-frequency all-fiber laser oscillator output power above 2 µm.
19 July 2022 in Optics Letters
In this paper, a novel, to the best of our knowledge, efficient pump scheme for an erbium-doped fluoride fiber laser with emission at 2.8 µm in the mid-infrared region is proposed and demonstrated. A singular pump source at 1.7 µm is used to excite Er3+ ions from ground state 4I15/2 to lower laser level 4I13/2, and then further boost the ions to 4I9/2, where a non-radiation transition occurs for the Er3+ ions to reach upper laser level 4I11/2. This scheme can efficiently recycle ions on the lower laser level 4I13/2 by excited-state absorption, therefore realizing population inversion and enhancing laser efficiency. In our demonstration, a 660-mW laser output at 2.8 µm is achieved from a 1.7-µm core-pumped erbium-doped fluoride fiber laser, where the slope efficiency versus launched pump power is 23.7%. The proposed innovative pump scheme shows great potential to realize high-power, high-efficiency erbium-doped fiber lasers at 2.8 µm.
21 December 2021 in Advanced Photonics Research
The saturable absorption effect of unpumped, rare earth‐doped fiber can be used as a method of achieving single‐frequency operation in fiber lasers. This effect in thulium‐doped fiber is used to achieve single‐frequency operation from an all‐fiber oscillator centered at 1720 nm. The characteristics of the saturable absorption effect are carefully studied and numerous operating regimes are identified wherein the oscillating state and frequency output characteristics of the laser can be manipulated via the injection of auxiliary pump light to the saturable absorber. A record single‐frequency output power of 2.56 W at 1720 nm is obtained; the slope efficiency is 44% and the laser linewidth is 3.3 kHz. The power scaling of the laser is only limited by the available power of the single‐mode 1570 nm pump source. Herein, new insights into methods of generating high‐power, single‐frequency emission from all‐fiber oscillators are offered.