1 March 2013 in Annals of Nuclear Energy
1 September 2013 in International Journal of Radiation Oncology - Biology - Physics (IJROBP)
FMFarshid Babapour Mofrad
+1
16 March 2020 in Journal of Radiotherapy in Practice
RHRoghiye B. Hosseinabadi
Introduction: In the recent years, some publications (mainly from one group of authors) have dealt with the effectiveness of proton–boron fusion therapy (PBFT). This theory is based on the Q-value of three produced α particles in the reaction of protons with boron (11B). They claim that this reaction significantly increases the absorbed dose in the target volume. However, the current study would re-evaluate their method to show if PBFT is really effective. Methods and materials: A parallel 80-MeV proton beam was irradiated on a water medium in a cubic boron uptake region (BUR). The two-dimensional dose distribution and percentage depth dose of protons, alphas and all particles were calculated using tally F6 and mesh-tallies by Monte Carlo N Particle Transport code. Results: The results not only showed that the dose enhancement in BUR is neglectable but also the higher density of BUR in comparison with water led to decrement of dose in this region. Because of low cross section of boron for proton beam (<100 mb), the α particles’ dose is 1,000 times lower than the proton dose. Conclusions: The physical aspects and the simulation results did not show any effectiveness of the PBFT for proton therapy dose enhancement.
1 January 2011 in Journal of Medical Physics
Electron field-shaping cerrobend cutouts on the linear accelerator applicator have some effects on the output and percentage depth dose. These effects which arise from the lateral scatter nonequilibrium are particularly evident in higher energies and in cutouts with smaller radius. Dose measurements for circular, square, and triangular cutouts as well as open field was performed in a 10 × 10 cm applicator, using plane parallel type ion chamber with a 100 cm source surface distance. The Percentage Depth Doses curves were drawn and the outputs were measured for each of these cutouts. The output factors, normalized to open 10 × 10 cm field, varied between 0.891 and 0.996 depending on the energy, cutout shape, and cavity area. With the use of cutouts, R 100 shifted toward the surface. The shifts ranged from 9 to 0 mm and from 13 to 0 mm for 12 and 14 MeV, respectively, depending on the shape and cavity area. For R 90 , R 80 , and R 50 the ranges for observed shifts narrowed down and practically no shifts were observed for R 20 . We present these changes in the form of predictive formulas, which would be useful in clinical applications.
1 June 2015 in Physica Medica
1 April 2013 in Radiation Measurements