Based on the notion that the local dark-matter field of axions or axionlike particles (ALPs) in our Galaxy induces oscillating couplings to the spins of nucleons and nuclei (via the electric dipole moment of the latter and/or the paramagnetic axion-wind effect), we establish the feasibility of a new method to search for ALPs in storage rings. Based on previous work that allows us to maintain the in-plane polarization of a stored deuteron beam for a few hundred seconds, we perform a first proof-of-principle experiment at the Cooler Synchrotron (COSY) to scan momenta near . This entails a scan of the spin-precession frequency. At resonance between the spin-precession frequency of deuterons and the ALP-induced electric dipole moment (EDM) oscillation frequency, there is an accumulation of the polarization component out of the ring plane. Since the axion frequency is unknown, the momentum of the beam and, consequently, the spin-precession frequency are ramped to search for a vertical polarization change that occurs when the resonance is crossed. At COSY, four beam bunches with different polarization directions are used to make sure that no resonance is missed because of the unknown relative phase between the polarization precession and the axion or ALP field. A frequency window of 1.5 kHz width around the spin-precession frequency of 121 kHz is scanned. We describe the experimental procedure and a test of the methodology with the help of a radio-frequency Wien filter located on the COSY ring. No ALP resonance is observed. As a consequence, an upper limit of the oscillating EDM component of the deuteron as well as its axion coupling constants are provided.
1 August 2016 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
The conventional Wien filter is a device with orthogonal static magnetic and electric fields, often used for velocity separation of charged particles. Here we describe the electromagnetic design calculations for a novel waveguide RF Wien filter that will be employed to solely manipulate the spins of protons or deuterons at frequencies of about 0.1 to 2 MHz at the COoler SYnchrotron COSY at J\"ulich. The device will be used in a future experiment that aims at measuring the proton and deuteron electric dipole moments, which are expected to be very small. Their determination, however, would have a huge impact on our understanding of the universe.Comment: 10 pages, 10 figures, 4 table
This review is a compilation of relevant concepts in designing Halbach multipoles for magnetic resonance applications. The main focus is on providing practical guidelines to plan, design and build such magnets. Therefore, analytical equations are presented for estimating the magnetic field from ideal to realistic systems. Various strategies of homogenizing magnetic fields are discussed together with concepts of opening such magnets without force or combining them for variable fields. Temperature compensation and other practical aspects are also reviewed. For magnetic resonance two polarities (di- and quadrupole) are of main interest, but higher polarities are also included.
30 March 2011 in Beilstein Journal of Nanotechnology
Beetles of the genus Melanophila and certain flat bugs of the genus Aradus actually approach forest fires. For the detection of fires and of hot surfaces the pyrophilous species of both genera have developed infrared (IR) receptors, which have developed from common hair mechanoreceptors. Thus, this type of insect IR receptor has been termed photomechanic and shows the following two special features: (i) The formation of a complex cuticular sphere consisting of an outer exocuticular shell as well as of a cavernous microfluidic core and (ii) the enclosure of the dendritic tip of the mechanosensitive neuron inside the core in a liquid-filled chamber. Most probably a photomechanic IR sensillum acts as a microfluidic converter of infrared radiation which leads to an increase in internal pressure inside the sphere, which is measured by a mechanosensitive neuron.A simple model for this biological IR sensor is a modified Golay sensor in which the gas has been replaced by a liquid. Here, the absorbed IR radiation results in a pressure increase of the liquid and the deflection of a thin membrane. For the evaluation of this model analytical formulas are presented, which permits the calculation of the pressure increase in the cavity, the deformation of the membrane and the time constant of an artificial leak to compensate ambient temperature changes. Some organic liquids with high thermal expansion coefficients may improve the deflection of the membrane compared to water.
A laser-driven spin-polarized 3He2+-beam source for nuclear–physics experiments and for the investigation of polarized nuclear fusion demands a high-density polarized He gas-jet target. Such a target requires a magnetic system providing a permanent homogeneous holding field for the nuclear spins plus a set of coils for adjusting the orientation of the polarization. Starting from a transport vessel at a maximum pressure of 3 bar, the helium gas is compressed for a short time and can be injected into a laser–interaction chamber through a non-magnetic opening valve and nozzle, thus forming jets with densities of about a few cm−3 and widths of about 1 mm. The target comprises a 3D adjustment system for precise positioning of the jet relative to the laser focus. An auxiliary gas system provides remote target operation and flushing of the gas lines with Ar gas, which helps to reduce polarization losses. The design of the target, its operation procedures and first experimental results are presented.
Cooling the junction of a scanning tunneling microscope to millikelvin temperatures is fundamental for high-resolution scanning tunneling spectroscopy. However, accurately determining the junction temperature has proven elusive, due to the microscopic dimension of the junction and its continuous energy exchange with the surrounding environment. Here, we employ a millikelvin scanning tunnelling microscope cooled by an adiabatic demagnetization refrigerator. Using normal-metal and superconducting tips, we perform scanning tunnelling spectroscopy on an atomically clean surface of Al(100) in a superconducting state. By varying the refrigerator temperatures between 30 mK and 1.2 K, we show that the temperature of the junction is decoupled from the temperature of the surrounding environment. To corroborate our findings, we simulate the scanning tunnelling spectroscopy data with P(E) theory and determine that the junction has a temperature of 77 mK, despite its environment being at 1.5 K.