7 March 2017 in Research in Nondestructive Evaluation
1 January 2020 in Scientific journal of the Ternopil national technical university
The fatigue life of aircraft structure elements with operational damage in the vicinity of the hole was investigated. The plates 60 mm wide and 6 mm thick made of D16chT aluminum alloy with a central hole were taken for the study. Fatigue damage was examined with an corner quarter-elliptical fatigue crack with a length of 1,25 mm, which was initiated from an edge notch of 0,5 x 0,5 mm. The fatigue crack growth rate on the surface of the plate after mandrel hole with cold expansion degree i = 2,7% increases up to15 times and residual lifetime in three times compared to the virgin plate.
27 February 2024 in Physicochemical Mechanics of Materials
Structure, physicоmechanical characteristics, and fracture micromechanisms under static and cyclic loading of samples cut from clad 2 mm thick sheet made of 1161АT alloy of the Al-Cu-Mg-Mn-Zr system with a reduced content of Si and Fe (up to 0.1 wt% of each) were studied. This alloy in the initial state (quenching and natural aging) and after the influence of termomechanical factor in laboratory conditions which simulate the effects of operational ones were investigated. The 1161AT alloy shows practically the same service characteristics in the initial state and after model degradation, contrary to similar alloys with an increased content of Si and Fe impurities (up to 0.5 wt% of each).
1 July 2024 in Materials Science
27 August 2021 in Aerospace technic and technology
ТМТатьяна Петровна Маслак
Corrosion of aircraft structures is one of the main factors limiting the duration of their operation, affecting on the economic efficiency and safety of air transport. Corrosion protection is performed at the stage of manufacturing aircraft structures, during their repair and operation. One of the additional measures of anti-corrosion protection is the use of film-forming coatings, which displace moisture from the gaps of structural joints, form a protective film, and also slow down the corrosion process. The protective properties of film-forming coatings are investigated by standard corrosion tests. At the same time, the specifics of aircraft structures and the possible side effects of the use of anti-corrosion compounds require special studies. The article presents an analysis of works in which the effect of film-forming anticorrosive compounds on the fatigue of elements of aircraft structures is considered.The main type of joints in the structure of modern aircraft are riveted joints. The high penetrating ability of film-forming materials ensures their penetration into the gaps of riveted joints, which, in some cases, can affect the frictional forces between the connected elements, which ensure the integrity of the joints. In some experimental investigations, the influence of film-forming compositions on the kinetics of fatigue crack growth is noted as a side effect. A number of possible mechanisms of deceleration and acceleration of the rate of crack propagation are considered. Experimental data concerning the effect of anticorrosive compounds on the fatigue of riveted joints and the process of propagation of fatigue cracks in structural materials, indicate the need to develop a universal methodology for the selection and use of film-forming compositions for the protection of aircraft structures from corrosion, taking into account the minimization or prevention of negative side effects on the service life of aircraft.