R. V. Chepil'

R. V. Chepil'

Auto-generated profile, based on publicly available information

R. V. Chepil'

Karpenko Physico-Mechanical Institute of the National Academy of Sciences of Ukraine, Lviv, Ukraine

Research Focus & Metrics

Academic Career Length

31Years (1996-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 December 2023 in Heliyon
Verified
Journal Article
Open access
VPViktoriya Podhurska
Viktoriya Podhurska
OKOleksandr Kuprin
Oleksandr Kuprin
TPTetiana Prikhna
Tetiana Prikhna
OOOrest Ostash
Orest Ostash
DPDarius Pohl
Darius Pohl
SPSemyon Ponomarov
Semyon Ponomarov
The paper studies oxidation resistance and electrical conductivity of dense coatings produced by vacuum-arc deposition technique on α-titanium thin (0.1 mm) substrate using a hot pressed Ti2AlC–TiC target. The coatings were deposited at low (7 mA/cm2) and high (15 mA/cm2) current densities on the substrate and marked LCD and HCD, respectively. This provided different local chemical and phase compositions of the coatings. It was found that phase compositions of the coatings differ from that of the target. The HCD coating has high oxidation resistance evaluated in terms of the specific weight gain (Δm/S = 0.06 mg/cm2) as well as high surface electrical conductivity (σ = 1.23·106 S/m) after long-term (1000 h) holding at 600 °C in the air due to the formation of an over thin (450 nm) Ti–Al-(C, O, N) near-surface layer. The thin titanium substrate with such Ti–Al–C coating is recommended as a lightweight interconnect of an intermediate-temperature solid oxide fuel cell.


1 January 1996 in Materials Science
Verified
Journal Article
Closed access
PDF file
VPV. V. Panasyuk
V. V. Panasyuk
OOO. P. Ostash
O. P. Ostash
EKE. M. Kostyk
E. M. Kostyk
RCR. V. Chepil'
R. V. Chepil'

1 January 2019 in Procedia Structural Integrity
Verified
Journal Article
Open access
RCRoman Chepil
Roman Chepil
OSOlena Stankevych
Olena Stankevych
OOOrest Ostash
Orest Ostash
BKBohdan Klym
Bohdan Klym

9 March 2026 in Physicochemical Mechanics of Materials
Verified
Journal Article
Closed access
VPViktoriya Podhurska
Viktoriya Podhurska
IKIlya Klimenko
Ilya Klimenko
RCR. V. Chepil
R. V. Chepil
ERE. M. Reshetnyak
E. M. Reshetnyak
YSYaroslav Shchur
Yaroslav Shchur
OOO. P. Ostash
O. P. Ostash
The composition, structure, mechanical characteristics, long-term oxidation resistance and electrical conductivity of coatings produced by vacuum-arc deposition method using a cathode (target) made of Ti–6.1Al–5.5Zr–2.3Sn–0.8Mn–0.6Si–0.4Mo–0.3Nb titanium alloy were studied. The coatings were deposited on a 0.5 mm thick substrate made of a cost-effective Ti–2.2Al–1.5Mn–0.3Zr–0.3Fe–0.1C alloy at a substrate bias voltage Ubias = –50…–200 V. The properties of the materials were compared in the as-received state and after long-term holding for 1000 h at 600°C in air, simulating the effect of the cathode environment in solid oxide fuel cells (SOFCs). It was established that the plates with a 10 mm thick coating at Ubias = -100 V exhibit high oxidation resistance (Δm/S = 0.88 mg/cm2) and surface electrical conductivity in the oxidized state (σ = 2.4×105 S/m) and meet the requirements for lightweight interconnect materials in cathode side of intermediate-temperature SOFCs.

4 September 2018 in Diagnostyka
Verified
Journal Article
Open access
RCRoman Chepil
Roman Chepil
VVVolodymyr Vira
Volodymyr Vira
YKYevhen Kharchenko
Yevhen Kharchenko
VKVolodymyr Kulyk
Volodymyr Kulyk
Zoia DuriaginaZoia Duriagina
Zoia Duriagina