The demand for high-performance permanent magnets continues to grow across a wide range of advanced technologies. However, conventional powder metallurgy routes for rare-earth magnets such as Sm-Co are limited by the intrinsic brittleness of the powders, reducing manufacturability and yield. Here, we report a single-step, solid-state processing method-friction consolidation (FC)-that enables simultaneous deformation, heating, and chemical transformation of brittle Sm-Co powders. Using commercial SmCo₅ powders containing Sm₂Co₇, FC induces a thermo-mechano-chemical pathway in which Sm₂Co₇ undergoes oxidation to form nanoscale SmCo(5-x) (where x < 1) and Sm₂O₃ phases. The heat generated from redox reactions and adiabatic shear deformation aids densification without requiring external thermal input. The extent of phase transformation is controlled by local strain and temperature during processing, with higher deformation levels leading to enhanced Sm₂Co₇ decomposition and improved saturation magnetization. This study demonstrates that FC offers a scalable, low-temperature route to consolidate brittle magnetic powders while refining their phase composition and microstructure. By tuning the starting powder chemistry and processing atmosphere, the approach reduces unwanted secondary phases and tailors the final magnetic response-offering a new pathway to fabricate high-performance Sm-Co magnets through a compact, energy-efficient process.
23 May 2025 in Materials Science and Engineering: A
Austenitic 304L stainless steel was irradiated with 5 MeV C ions to selected doses of 10 and 100 dpa at temperatures between 30 and 850 °C to examine how irradiation temperature influences defect evolution, microstructural changes, and mechanical response. At 30 °C and 100 dpa, irradiation produced dense defect populations, including dislocation loops and a carbon-rich damaged region near the calculated damage peak, accompanied by measurable irradiation hardening. At 500 °C and 100 dpa, increased defect mobility promoted void formation and Ni–Si segregation to irradiation-induced defect structures, with positron annihilation measurements indicating an increased contribution from vacancy-type defects. At 850 °C, thermal recovery and high-temperature microstructural reorganization reduced the net hardening response and were accompanied by carbide and sulfide precipitation. XRD and EBSD confirmed that the microstructure retained a primarily FCC austenitic matrix with a minor BCC/martensitic phase, whose measured fraction varied with irradiation condition. Overall, these results show that C-ion irradiation of 304L stainless steel produces distinct defect and microstructural responses depending on irradiation temperature, with low-temperature defect accumulation, intermediate-temperature void formation and segregation, and high-temperature recovery and precipitation all contributing to the observed mechanical behavior.