This work proposes the dual axis solar tracker with mirror reflection for optimum output of solar panel by using arduino unoR3 as the control unit. The objectives of this work are to track and optimize the maximum output power of the solar panel by designing and developing a dual axis solar tracker with mirror reflection. The system includes a 10 watt solar panel, an arduino unoR3 and a customized mechanical body to carry the solar panel. This system will track and detect the angle of the sun to locate the surface of solar panel at the position and the angle where it can get maximum amount of energy. The sensors will detect the position of the sun and servo motors act as free moving neck to make it easier to move freely depending on the angle detected. The Light Depending Resistor (LDR) will be used in tracking system. These LDR will detect the existence of sunlight and therefore the mechanical hardware will move horizontal and vertical axis depending on the value of LDR detected to follow the angular degree of sun in order to get maximum and best result of absorbing energy. The final result obtained from dual axis solar tracker showed that the output power has been maximized compared to stationary panel. Based on the experimental result, it show that the designed system successful improve the performance of the solar panel.
Overcurrent relay is an important relay used to protect transmission and distribution feeders, transformer, bus coupler etc. It can be used as main or backup protection relays. The modeling of overcurrent relay and other protection relays is important in the research on the effects of network parameters and configurations on the operation of these relays. This research deal with modeling and simulation of inverse time overcurrent relay using commonly used Matlab/Simulink software. The developed model was tested with single line to ground fault and phase to phase fault with various fault locations and fault resistances to evaluate phase and earth detectors in sensing the fault current. Simulations results show the feasibility of the software to be used to develop the relay.
The goal of this research is to design a dynamic model of distribution network cell (DNC) using artificial neural network (ANN) approach. The development of dynamic model using artificial intelligent (AI) has been increased over the year which some of AI method is more complicated like fuzzy system that needs fuzzy rule to develop the model. So, there is need for other method that is more simple and accurate. In this project, the DNC model using ANN was developed using MATLAB programming. This research consists of two models which are for active and reactive power based on frequency and input voltage. The active and reactive power responses from the ANN model were compared to the response from the full DNC model at various type of disturbance. The response of full DNC model was obtained from the UK 11 kV distribution network model. The model was developed using DigSILENT PowerFactory software. The performance of the ANN model was validated by calculating the value of root means square error (RMSE) and the best fit value. Later, the performance of the ANN model was also compared to the fuzzy model and system identification model. The results obtained show that the ANN model was more simpler as no parameters involved in developing the equivalent model. The efficiency was also good based on the high best fit value compared to fuzzy system model and system identification model. In conclusion, the equivalent dynamic model of DNC based on ANN system approach was successfully developed.