Thin film lead halide perovskite cells, where the perovskite layer is deposited directly onto a flat titania blocking layer, have reached AM 1.5 efficiencies of over 15%,1 showing that the mesoporous scaffold used in early types of perovskite solar cells is not essential. We used a variety of techniques to gain a better understanding of thin film perovskite cells prepared by a solution-based method. Twelve cells were studied, which showed AM 1.5 efficiencies of ∼11%. The properties of the cells were investigated using impedance spectroscopy, intensity-modulated photovoltage spectroscopy (IMVS), intensity-modulated photocurrent spectroscopy (IMPS), and open-circuit photovoltage decay (OCVD). Despite the fact that all 12 cells were prepared at the same time under nominally identical conditions, their behavior fell into two distinct groups. One half of the cells exhibited ideality factors of m ≈ 2.5, and the other half showed ideality factors of m ≈ 5. Impedance spectroscopy carried out under illumination at open circuit for a range of intensities showed that the cell capacitance was dominated by the geometric capacitance of the perovskite layer rather than the chemical or diffusion capacitance due to photogenerated carriers. The voltage dependence of the recombination resistance gave ideality factors similar to those derived from the intensity dependence of the open-circuit voltage. The IMVS time constant was determined by the product of the geometric capacitance and the recombination resistance. The two types of cells gave very different OCVD responses. The cells with m ≈ 2.5 showed a persistent photovoltage effect that was absent in the case of the cells with higher ideality factors. The IMPS responses provide evidence of minor efficiency losses by recombination under short-circuit conditions.
25 January 2007 in Physical Chemistry Chemical Physics
The basic physical and chemical principles behind the dye-sensitized nanocrystalline solar cell (DSC: also known as the Grätzel cell after its inventor) are outlined in order to clarify the differences and similarities between the DSC and conventional semiconductor solar cells. The roles of the components of the DSC (wide bandgap oxide, sensitizer dye, redox electrolyte or hole conductor, counter electrode) are examined in order to show how they influence the performance of the system. The routes that can lead to loss of DSC performance are analyzed within a quantitative framework that considers electron transport and interfacial electron transfer processes, and strategies to improve cell performance are discussed. Electron transport and trapping in the mesoporous oxide are discussed, and a novel method to probe the electrochemical potential (quasi Fermi level) of electrons in the DSC is described. The article concludes with an assessment of the prospects for future development of the DSC concept.
The kinetics of light-driven oxygen evolution at polycrystalline α-Fe2O3 layers prepared by aerosol-assisted chemical vapour deposition has been studied using intensity modulated photocurrent spectroscopy (IMPS). Analysis of the frequency-dependent IMPS response gives information about the competition between the 4-electron oxidation of water by photogenerated holes and losses due to electron-hole recombination via surface states. The very slow kinetics of oxygen evolution indicates the presence of a kinetic bottleneck in the overall process. Surface treatment of the α-Fe2O3 with dilute cobalt nitrate solution leads to a remarkable improvement in the photocurrent response, but contrary to expectation, the results of this study show that this is not due to catalysis of hole transfer but is instead the consequence of almost complete suppression of surface recombination.