This study presents a methodology to define the most adequate artificial lift technique based on the method limitation itself, suitability coefficient (based on an attributes table) and economic analysis towards horizontal wells configuration. The technical limitations of each method have been determined based on physical principles and experience reported in open literature. An attribute matrix has been generated based on the information provided in open literature. A breakdown of operational and capital cost is proposed to compare the equivalent cost of each method based on how long the method will last and how often well interventaions are required. A field example is presented to demonstrate the use of the proposed methodology.
11 March 2024 in Geoenergy Science and Engineering
The effect of downward and upward pipe inclinations on flow characteristics for high viscosity oil-gas two-phase flow was experimentally studied. 400 experimental tests were conducted in a 50.8-mm ID pipe for ±2° inclinations. Four different oil viscosities, namely, 0.585, 0.378, 0.257 and 0.181 Pas, were considered. Superficial gas and liquid velocity varied from 0.1 to 3.5 m/s and 0.1 to 0.8 m/s, respectively. Flow pattern and pressure drop are reported. The experimental results were used to evaluate different flow pattern maps, models and two-phase flow correlations.
An experimental study of the inclination angle (±2° from horizontal) effects on high viscosity oil and gas two-phase flow has been conducted, and the available multiphase flow models/correlations have been evaluated using the acquired data. The effect of pipe inclination on the slug flow characteristics of highly viscous oil-gas two-phase flow was studied based on 1,040 data points covering a wide range of experimental conditions and liquid viscosities in a 50.8-mm-ID pipe at 2° downward and upward inclinations from horizontal. The oil viscosity ranged from 155 cP to 587 cP. Superficial liquid and gas velocities varied from 0.1 m/s to 0.8 m/s and from 0.1 m/s to 5 m/s, respectively. The basic two-phase flow parameters and slug flow characteristics have been analyzed and compared with the past studies conducted for near horizontal pipes.
1 May 2017 in International Journal of Multiphase Flow