14 August 2018 in IEEE Internet of Things Journal
In order to overcome the shortcomings of orthogonal frequency division multiplexing (OFDM) and prolong the battery life of devices in the Internet of Things, a joint subcarrier and subsymbol allocation-based simultaneous wireless information and power transfer scheme for multiuser generalized frequency division multiplexing (GFDM) system is proposed in this paper. According to the 2-D time-frequency block structure of GFDM, we investigate the problem to maximize sum information decoding (ID) rate by optimizing subcarrier and subsymbol allocation, power allocation and power splitting ratio under the constraints of total transmit power and harvested energy. To solve the nonconvex problem, an iterative algorithm is developed to obtain its optimal solution. The performances of sum ID rate and harvested energy are simulated and evaluated. Simulation results show that the proposed algorithm converges fast. Moreover, the proposed algorithm can not only allocate the subcarriers, subsymbols, and power based on different channel conditions of users, but also outperform the conventional OFDM in sum ID rate on the premise of satisfying the minimum harvested energy of each user.
15 April 2019 in IEEE Access
Green and sustainable communications are crucial for cellular devices and the Internet of Things (IoT) devices in the fifth generation (5G) mobile communication system. Wireless-powered communication (WPC) provides a successful technical paradigm to support wireless information transmission for mobile devices by using harvested radio-frequency (RF) energy. In the meantime, non-orthogonal multicarrier transmission techniques, typically represented by the generalized frequency-division multiplexing (GFDM), can not only enhance spectrum efficiency but also improve the flexibility of resource allocation due to its fine-granularity sub-block. In this paper, a GFDM-based cooperative relay system model is proposed to improve the quality of experience of the cell-edge user. Specifically, the system is composed of one source node, one destination node (cell-edge user), and one relay node. The source node transmits a signal to the destination node and the relay node. The relay node performs information transmission and power transfer to the destination node by using different GFDM sub-block sets. The destination node combines the signals from the source node and relay node. In order to maximize the information rate at the destination node subject to the minimum harvested energy, a joint sub-block, sub-block power, and subslot allocation-based WPC scheme is proposed. To solve the non-convex optimization problem, an iterative algorithm is proposed and its effectiveness is validated by simulations. The simulation results demonstrate that the GFDM-based WPC scheme outperforms the orthogonal frequency-division multiplexing (OFDM), and the subslot optimization can significantly increase the information rate at the destination node.
18 September 2006 in IEEE Signal Processing Letters
Adopting ultra-short impulses in ultra-wide bandwidth (UWB) transmission make systems vulnerable to timing-jitter. To overcome this challenge, we propose a timing-hopping high-order waveform modulation scheme in this letter. Central to our design is the adaptation of a high-order monocycle (HOM) that can provide timing-jitter robust UWB communications