15 April 2019 in IEEE Access
Green and sustainable communications are crucial for cellular devices and the Internet of Things (IoT) devices in the fifth generation (5G) mobile communication system. Wireless-powered communication (WPC) provides a successful technical paradigm to support wireless information transmission for mobile devices by using harvested radio-frequency (RF) energy. In the meantime, non-orthogonal multicarrier transmission techniques, typically represented by the generalized frequency-division multiplexing (GFDM), can not only enhance spectrum efficiency but also improve the flexibility of resource allocation due to its fine-granularity sub-block. In this paper, a GFDM-based cooperative relay system model is proposed to improve the quality of experience of the cell-edge user. Specifically, the system is composed of one source node, one destination node (cell-edge user), and one relay node. The source node transmits a signal to the destination node and the relay node. The relay node performs information transmission and power transfer to the destination node by using different GFDM sub-block sets. The destination node combines the signals from the source node and relay node. In order to maximize the information rate at the destination node subject to the minimum harvested energy, a joint sub-block, sub-block power, and subslot allocation-based WPC scheme is proposed. To solve the non-convex optimization problem, an iterative algorithm is proposed and its effectiveness is validated by simulations. The simulation results demonstrate that the GFDM-based WPC scheme outperforms the orthogonal frequency-division multiplexing (OFDM), and the subslot optimization can significantly increase the information rate at the destination node.
12 March 2018 in IEEE Access
As one of the candidate waveforms for 5G, Generalized Frequency Division Multiplexing (GFDM) is a flexible non-orthogonal multicarrier technique. Similar to Orthogonal Frequency Division Multiplexing (OFDM), GFDM communication system suffers from Symbol Timing Offset (STO) and Carrier Frequency Offset (CFO) caused by multipath effect and Doppler shift. In this paper, we design a pseudo noise (PN) based preamble and propose an approach for signal synchronization. The preamble is composed of two identical PN sequences whose autocorrelation and cross-correlation are better than Cyclic Prefix (CP). STO can be detected by calculating the correlation coefficient between the local PN sequence of receiver and the corresponding preamble part of sliding window. These two adjacent PN sequences can be used to calculate phase offset value by Fourier transform, and then obtain CFO value. Simulation results demonstrate that, compared with conventional CP-based synchronization, the proposed approach has the lower Mean Square Error (MSE) and Symbol Error Rate (SER) at the cost of just a little bit more bandwidth.
15 November 2018 in IEEE Access
High-efficiency utilization of resources has always been the major concern and design objective in the Internet of Things (IoT). In this paper, an Orthogonal Frequency Division Multiplexing (OFDM) based wireless system model for IoT is proposed where the Simultaneous Wireless Information and Power Transfer (SWIPT) and the Non-Orthogonal Multiple Access (NOMA) are jointly used to improve the energy and spectrum utilization. Specifically, terminals can decode information and harvest energy simultaneously in the downlink, and transmit signals to the Access Point (AP) in the uplink. Then, the AP decodes terminals’ information based on NOMA. A joint uplink and downlink resource allocation scheme is proposed with the optimization objective to maximize the sum information decoding rate in the uplink under the condition that the target sum information decoding rate in the downlink is guaranteed. To solve the optimization problem, a two-step algorithm is proposed. For the first step, a joint subcarrier and power allocation algorithm is designed to maximize the harvested energy of terminals in the downlink. For the second step, a subslot optimization algorithm is designed to increase the sum information decoding rate in the uplink. Simulation results demonstrate that, compared with the conventional algorithms, the proposed algorithm can not only achieve the maximization of harvested energy, but also support higher sum information decoding rate in the uplink.