Jaime Odar Honorio Acosta

Jaime Odar Honorio Acosta

Auto-generated profile, based on publicly available information

Jaime Odar Honorio Acosta

Universidad Nacional de Jaén

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2026 in Revista Científica Pakamuros
Verified
Journal Article
Open access
PDF file
LSLuis Miguel Llanos Sanchez
Luis Miguel Llanos Sanchez
FMFrans Fuentes Maza
Frans Fuentes Maza
RYRicardo Angel Shimabuku Ysa
Ricardo Angel Shimabuku Ysa
MAMario Félix Olivera Aldana
Mario Félix Olivera Aldana
JAJaime Odar Honorio Acosta
Jaime Odar Honorio Acosta
BSBoy George Vásquez Sandoval
Boy George Vásquez Sandoval
The cutting tools used in heavy machinery are subjected to severe abrasion, impact, and cyclic loading conditions, which cause progressive material loss and reduce their service life. The objective of this research was to evaluate the structural integrity of cutting tools restored by submerged arc welding (SAW) in order to determine their feasibility for reuse. The restoration process was carried out using T-500 wear-resistant steel, 3.2 mm EL-12 welding wire, and R35Mo flux, with welding parameters of 350 A, 30 V, and a travel speed of 30 cm/min. Microstructural and chemical composition analyses were performed, together with tensile, impact, hardness, and wear tests, complemented by structural and fatigue analyses. The average tensile strength was 1014.5 MPa, with fracture occurring in the base metal, while the average absorbed impact energy was 124.13 J. The welded zone exhibited an average wear rate of 0.01040 g/min compared with 0.01400 g/min for the base metal, representing a 25.7% reduction. Fatigue analysis estimated 61,447 cycles to reach total cumulative damage. The results demonstrate the technical feasibility of the SAW process for restoring the cutting tools evaluated.

30 June 2025 in Revista Científica Pakamuros
Verified
Journal Article
Open access
PDF file
FMFrans Fuentes Maza
Frans Fuentes Maza
RYRicardo Ángel Shimabuku Ysa
Ricardo Ángel Shimabuku Ysa
MAMario Félix Olivera Aldana
Mario Félix Olivera Aldana
JAJaime Odar Honorio Acosta
Jaime Odar Honorio Acosta
JJJannier Alberto Montenegro Juárez
Jannier Alberto Montenegro Juárez
MPManuel Emilio Milla Pino
Manuel Emilio Milla Pino
The purpose of this research was to analyse the influence of the improvement plans on the learning indicators measured in the subjects Electropneumatic Automation and Transformers and Transmission Lines taught in the professional career of Mechanical and Electrical Engineering at the National University of Jaén, Cajamarca, Peru. The improvement plans are aimed at strengthening the quality of the teaching-learning process and were implemented starting in 2020. The measurement and evaluation of learning was carried out according to the following stages: definition of the educational objectives of the programme, construction of the matrix of the contribution of the subjects in the learning indicators, selection of the subjects and elaboration and implementation of the improvement plans. The learning indicators obtained from the implementation of the improvement plans were processed following the established guidelines for an analysis of variance and Tukey's multiple comparisons test, obtaining evidence that indicates the existence of highly significant differences when comparing semesters and learning indicators with respect to the percentage of the level of achievement reached, which reflects the influence of the improvement plans that acquire a continuous character when applied semester after semester