This article describes the application of high-resolution X-ray computed tomography to assess the critical parameters of refractive lenses for X-ray optics that determine the quality of compound optical systems. A microfocus Y. Cheetah X-ray system has been used for three-dimensional visualization of the surface and internal structure of refractive lenses made of high-purity aluminum with geometric apertures of 500 and 1500 μm. A Fein Focus X-ray tube with a focal spot size of less than 2 μm provides the resolution necessary for detecting critical-size microstructure defects in the material of the lens.
The article studies the porous ceramics consisting of ultra-fine powders. The porosity of ceramic samples varied from 15% to 80%. The structure of the ceramic materials had a cellular configuration. The distinctive feature of all experimentally obtained strain diagrams is their nonlinearity at low deformations characterized by the parabolic law. It was shown that the observed nonlinear elasticity for low deformations shown in strain diagrams is due to the mechanical instability of cellular elements of the ceramic framework.
A computer simulation approach to sintering of low-temperature ceramics has been developed within the framework of the micromechanics of heterogeneous media. It is taken into account that the...
It is suggested that a non-destructive testing technique using a three-dimensional X-ray tomography be applied to detecting internal structural defects and monitoring damage formation in a ceramic composite structure subjected to a bending load. Three-point bending tests are used to investigate the fatigue behavior and mechanical and physical properties of medical-grade ZrO2-based ceramics. The bending strength and flexural modulus are derived under static conditions at a loading rate of 2 mm/min. The fatigue strength and fatigue limit under dynamic loading are investigated at a frequency of 10 Hz in three stress ranges: 0.91–0.98, 0.8–0.83, and 0.73–0.77 MPa of the static bending strength. The average values of the bending strength and flexural modulus of sintered specimens are 43 MPa and 22 GPa, respectively. The mechanical properties of the ceramics are found to be similar to those of bone tissues. The testing results lead us to conclude that the fatigue limit obtained from 105 stress cycles is in the range 33–34 MPa, i.e. it accounts for about 75% of the static bending strength for the test material.