Materials Research Laboratory, Department of Physics, Faculty of Basic and Applied Sciences (FBAS), International Islamic University (IIU), Islamabad, Pakistan
Auto-generated profile, based on publicly available information
Muhammad Mumtaz
Materials Research Laboratory, Department of Physics, Faculty of Basic and Applied Sciences (FBAS), International Islamic University (IIU), Islamabad, Pakistan
We synthesized/(Cu0.5Tl0.5)Ba2Ca3Cu4 /CuTl-1234= 0~3 wt.%nanoparticles-superconductor composites by solid-state reaction technique and examined the effects of zinc (Zn) nanoparticles on structural and superconducting properties of CuTl-1234 phase. Unaltered crystal structure of host CuTl-1234 phase confirmed the existence of Zn nanoparticles at intercrystallite sites. We observed an improvement in grains size and intergrains connectivity by healing up the voids after incorporation of Zn nanoparticles in CuTl-1234 superconductor. Superconducting properties of/CuTl-1234 composites were suppressed for all Zn nanoparticles concentrations. Suppression of zero resistivity critical temperatureand variation in normal state resistivity (Ω-cm)were attributed to reduction of superconducting volume fractions and enhanced scattering cross section of mobile carriers.
Silver (Ag) nanoparticles were added into (Cu0.5Tl0.5)Ba2Ca2Cu3O10−δ (CuTl-1223) high Tc superconducting matrix to get (Ag)x/CuTl-1223, x = 0, 0.5, 1.0, 2.0, and 4 wt. %, nano-superconductor composites. The activation energy {U (eV)} and zero resistivity critical temperature {Tc (0)} were increased with increasing contents of Ag nanoparticles in (CuTl-1223) phase up to x = 2.0 wt. %. The increase of activation energy is most probably due to interaction of carriers with the metallic Ag nanoparticles present at grain boundaries of the host CuTl-1223 superconducting matrix. The systematic increase in Tc (0) and gradual decrease in normal state resistivity {ρ300 K (Ω cm)} may be due to improved inter-grains coupling by filling up the voids and pores with the inclusion of metallic Ag nanoparticles at the grain-boundaries. There are two possible mechanisms associated with the inclusion of Ag nanoparticles, one is the formation of non-superconducting regions causing the increase of activation energy and other (dominating) is the improved inter-grains connectivity promoting Tc (0). The microscopic parameters (i.e., zero temperature coherence length along c-axis {ξc (0)}, inter-layer coupling (J), inter-grain coupling (α), etc.) deduced from the fluctuation induced conductivity analysis reasonably explained the experimental findings.
27 September 2012 in Journal of Low Temperature Physics