Tianyi Li

Tianyi Li

Auto-generated profile, based on publicly available information

Tianyi Li

Department of Physics and Tsinghua-Foxconn Nanotechnology Research Center, Tsinghua University, Beijing 100084, China

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 September 2017 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
LMLimin Ma
Limin Ma
Zhengang LuZhengang Lu
Zhengang Lu
JTJiubin Tan
Jiubin Tan
JLJian Liu
Jian Liu
XDXuemei Ding
Xuemei Ding
LHLing Hao
Ling Hao

6 February 2023 in PRX Quantum
Verified
Journal Article
Open access
PDF file
FMFabian Marxer
Fabian Marxer
AVAntti Vepsäläinen
Antti Vepsäläinen
SJShan W. Jolin
Shan W. Jolin
JTJani Tuorila
Jani Tuorila
ALAlessandro Landra
Alessandro Landra
JHJohannes Heinsoo
Johannes Heinsoo
Tunable coupling of superconducting qubits has been widely studied due to its importance for isolated gate operations in scalable quantum processor architectures. Here, we demonstrate a tunable qubit-qubit coupler based on a floating transmon device, which allows us to place qubits at least 2 mm apart from each other while maintaining over 50-MHz coupling between the coupler and the qubits. In the introduced tunable-coupler design, both the qubit-qubit and the qubit-coupler couplings are mediated by two waveguides instead of relying on direct capacitive couplings between the components, reducing the impact of the qubit-qubit distance on the couplings. This leaves space for each qubit to have an individual readout resonator and a Purcell filter, which is needed for fast high-fidelity readout. In addition, simulations show that the large qubit-qubit distance significantly lowers unwanted non-nearest-neighbor coupling and allows multiple control lines to cross over the structure with minimal crosstalk. Using the proposed flexible and scalable architecture, we demonstrate a controlled-Z gate with (99.81±0.02)% fidelity.

9 December 2016 in Nanoscale
Verified
Journal Article
Closed access
PDF file
JLJinhui Liu
Jinhui Liu
TLTianyi Li
Tianyi Li
YHYudong Hu
Yudong Hu
XZXing Zhang
Xing Zhang
The thermal conductivity of individual suspended single-walled carbon nanotubes (SWCNTs) has been theoretically predicated to increase with length but this has never been verified experimentally. This then leads to the question of whether the thermal conductivity saturates to a finite constant value in ultra-long SWCNTs. This paper reports on experimental measurements of the thermal conductivity of individual suspended SWCNTs as a function of the characteristic thermal transport length using the same individual suspended SWCNT sample. Interestingly, at around 360 K, the thermal conductivity first increases with increasing characteristic length and then saturates to a finite constant value at a characteristic length of ∼10 μm. These experimental results provide a fundamental understanding of the phonon transport characteristics in suspended, pristine SWCNTs.

8 September 2015 in Scientific Reports
Verified
Journal Article
Open access
PDF file
YBYue Bai
Yue Bai
HWHuaqiang Wu
Huaqiang Wu
KWKun Wang
Kun Wang
RWRiga Wu
Riga Wu
LSLin Song
Lin Song
HQHe Qian
He Qian
There are two critical challenges which determine the array density of 3D RRAM: 1) the scaling limit in both horizontal and vertical directions; 2) the integration of selector devices in 3D structure. In this work, we present a novel 3D RRAM structure using low-dimensional materials, including 2D graphene and 1D carbon nanotube (CNT), as the edge electrodes. A two-layer 3D RRAM with monolayer graphene as edge electrode is demonstrated. The electrical results reveal that the RRAM devices could switch normally with this very thin edge electrode at nanometer scale. Meanwhile, benefited from the asymmetric carrier transport induced by Schottky barrier at metal/CNT and oxide/CNT interfaces, a selector built-in 3D RRAM structure using CNT as edge electrode is successfully fabricated and characterized. Furthermore, the discussion of high array density potential is presented.

7 December 2010 in Nanotechnology
Verified
Journal Article
Closed access
LXLin Xiao
Lin Xiao
YZYuying Zhang
Yuying Zhang
YWYang Wang
Yang Wang
Kai LiuKai Liu
Kai Liu
ZWZheng Wang
Zheng Wang
KJKaili Jiang
Kaili Jiang
Carbon nanotube (CNT) films, easily drawn from super-aligned CNT arrays with a large area and a good compatibility with semiconductor technology, have been used as light sensitive materials for infrared (IR) detection. A bolometric CNT detector made from one layer of super-aligned CNT film shows a 15.4% resistance change under 10 mW mm(-2) of IR illumination and a fast characteristic response time of 4.4 ms due to its ultra-small heat capacity per unit area in vacuum at room temperature. Besides the power intensity detection, the anisotropic property of the super-aligned CNT films makes them ideal materials to detect the polarization of IR light simultaneously, which provides great potential in infrared imaging polarimetry. Theoretical analyses have been carried out to investigate the influences of CNT film properties on the responsivity and response time of the detector.

29 August 2015 in Nano Research
Verified
Journal Article
Closed access
PDF file
WWWenyun Wu
Wenyun Wu
JYJingying Yue
Jingying Yue
XLXiaoyang Lin
Xiaoyang Lin
DLDongqi Li
Dongqi Li
FZFangqiang Zhu
Fangqiang Zhu
KJKaili Jiang
Kaili Jiang
Single-walled carbon nanotubes (SWCNTs) illuminated by white light should appear colored due to resonance Rayleigh scattering. However, true-color imaging of SWCNTs on substrates has not been reported, because of the extremely low scattering intensity of SWCNTs and the strong substrate scattering. Here we show that Rayleigh scattering can be greatly enhanced by the interface dipole enhancement effect. Consequently colorful SWCNTs on substrates can be directly imaged under an optical microscope by wide field supercontinuum laser illumination, which facilitates high throughput chirality assignment of individual SWCNTs. This approach, termed “Rayleigh imaging microscopy”, is not restricted to SWCNTs, but widely applicable to a variety of nanomaterials, which enables the colorful nanoworld to be explored under optical microscopes.